Publicidad
- 4C: Lockout mode.
- 10H: Switch to Advanced UI.
- 15C or more: Version check.
In Lockout mode with Simple UI, there are a few functions:
- 1H: Momentary moon
- 2H: Momentary low
- 4C: Unlock and turn on
- 4H: Unlock and turn on at low level
- 5C: Unlock and turn on at high level
To change between Simple UI and Advanced UI, turn the light off and then do one of these:
In Simple UI:
- 10H: Go to Advanced UI.
In Advanced UI:
- 10C: Go to Simple UI.
- 10H: Configure Simple UI.
If you get lost, or if you want to auto-calibrate the temperature sensor, do a Factory Reset. The process for this
is:
- Loosen body tube
- Hold button
- Tighten body tube
- Keep holding button for about 4s
The light should flicker while getting brighter, then briefly burst to full power. Hold until it reaches full power
to do a reset, or let go of the button early to abort.
Advanced UI
Advanced UI has all the advanced functions which are fun to play with but also hard to learn. Please refer the
UI diagram below. Please ask us for pdf file so you can ready easily. We can also send video link to show
how to play with Anduril2
Publicidad
