Publicidad
Idiomas disponibles
Idiomas disponibles
GB
6. Tension the saw chain (Tensioning and
slackening the saw chain (07)).
4.2
Tensioning and slackening the saw
chain (07)
1. Slightly loosen the fastening nut of the cover.
2. Tension the saw chain; use the combination
spanner:
■
Tensioning the saw chain: Turn the chain
tensioning screw (07/1) clockwise (07/a).
■
Slackening the saw chain: Turn the chain
tensioning screw (07/1) anti-clockwise
(07/b).
3. Check the chain tension (see chapter 5.2
"Checking the chain tension", page 27). Re-
peat the previous step if necessary.
4.3
Filling saw chain oil (08)
There is no appliance saw chain oil in the ap-
pliance upon delivery.
IMPORTANT!
Danger of damage to the appliance
Use of the appliance without saw chain
oil leads to damage of the saw chain
and the guide rail.
■
Never operate the appliance without
saw chain oil.
■
Before starting work, fill the saw
chain oil in the oil tank and check
the oil level during the work.
■
At least before starting work each
time, check that the chain lubrication
is working.
The service life and cutting performance of the
saw chain depend on optimum lubrication. The
saw chain has oil applied to it automatically
during operation.
IMPORTANT!
Danger of damage to the appliance
Due to the metallic abrasion it contains,
the use of used oil for lubricating the
chain would lead to premature wear of
the guide rail and saw chain. Also, the
warranty of the manufacturer will be-
come void.
■
Never use used oil, only biologically
degradable saw chain oil.
26
IMPORTANT!
Danger of environmental damage
The use of mineral oil for the chain lubri-
cation leads to serious environmental
damage.
■
Never use mineral oil, but only bio-
logically degradable saw chain oil.
Each time before starting work or changing the
rechargeable battery, check the oil level and re-
plenish the saw chain oil if necessary:
1. Check the oil level in the viewing aperture
(08/1) of the oil tank. It must always be possi-
ble to see oil. The minimum and the maxi-
mum oil level must not be exceeded.
2. Place and hold the polemounted pruner hori-
zontal on a firm surface.
3. Clean the appliance around the oil tank cap
(08/2).
4. Unscrew the oil tank cap (08/2).
5. Fill the oil tank with biologically degradable
saw chain oil. While doing so, check the oil
level in the viewing aperture (08/1) of the oil
tank. Do not allow it to overrun.
■
Use a funnel for easier filling.
■
Do not allow any dirt to get into the oil
tank.
6. Screw down the oil tank cap (08/2) again.
4.4
Attaching the carrying belt to the basic
appliance
See "Multitool MT 42 – basic appliance" operat-
ing instructions.
4.5
Putting the attachment on the basic
appliance
See "Multitool MT 42 – basic appliance" operat-
ing instructions.
5 OPERATION
CAUTION!
Danger of burns
The gearbox housing becomes hot
during operation.
■
Do not touch the gearbox housing.
5.1
Switching the appliance on and off
See "Multitool MT 42 – basic appliance" operat-
ing instructions.
Operation
CSA 4220
Publicidad
