Publicidad
Idiomas disponibles
Idiomas disponibles
STARTING/STOPPING THE MACHINE (Fig. J)
To Start
1. Move the lock-off lever forward and then press the
trigger switch to start.
2. Different pressure on the trigger results in variable
rotating speed of the cutting unit. Adjust the speed to
suit the task at hand.
NOTICE:
The motor starts only when the lock-off lever is
moved forward and the trigger switch is depressed at the
same time.
To Stop
Move the machine away from the cutting area and release
the trigger switch to stop it.
WARNING:
Always remove the battery pack from
the machine during work breaks and after finishing work.
J-1 Lock-off Lever
CHANGING SPEED MODE (FIG. K)
The machine features three speed modes.
Every time press the speed mode switch, the speed mode
will change.
Indicator Lights
Solid green
Flashing green
Solid red
Battery-status
Flashing red
indicator
Solid orange
Flashing red/
green alternately
J-2 Trigger Switch
56 VOLT LITHIUM-ION CORDLESS LINE TRIMMER — STX4500
The speed indicator will display the active speed status:
one light for low speed, two lights for medium speed,
three lights for high speed. The low speed mode provides
better control of the machine and longer operating time
per charge.
NOTICE:
The speed mode can be set before the machine is turned
on OR during operation.
When the machine is re-started after a break, the speed
mode will return to the previous speed.
K-1 Speed Indicator
K-2 Bluetooth
®
Indicator K-4
BATTERY-STATUS INDICATOR AND SPEED
INDICATOR (FIG. K)
The battery-status indicator shows the charge level and
the working status of the battery pack, and the speed
indicator shows the working status of the machine as
shown in the chart below. The battery-status indicator
and the speed indicator will illuminate when the machine
is started OR the speed mode button is pressed.
Meaning
Battery charge level of 20% to 100%
Battery charge level of 10% to 20%
Battery charge level of less than 10%
The battery pack is nearly depleted and needs
to be charged immediately.
The battery pack is overheated. Cool the battery
pack until the temperature drops below 67°C.
See " Battery High-Temperature Protection
" below
The battery pack electronics error. Replace
the battery pack or contact EGO customer
service center. See " Battery Electronics Error
Protection " below.
K-3 Speed Mode Button
Battery-status
Indicator
11
EN
Publicidad
