Publicidad
Idiomas disponibles
Idiomas disponibles
EN
Speed indicator
(the illustration
shows the high
speed)
Battery High-Temperature Protection
If the battery temperature exceeds 70°C during operation,
the temperature-protection circuit will immediately
shut off the machine to protect the battery pack from
overheating damage. The battery-status indicator will
glow solid orange. Release the trigger and wait until the
overheated battery cools down and the indicator turns
green, then restart the machine.
Battery Electronics Error Protection
When the battery pack electronics error occurs, the
battery-status indictor will flash red/green alternately
and the machine will shut off in 3 seconds. Replace the
battery pack or contact EGO customer service center.
Machine Overload Protection
This machine has built-in overload circuit protection.
When the machine is overloaded, the motor will stop
and the speed indicator will flash orange. Remove the
battery pack from the machine, then reattach the battery
pack and restart the machine. Decrease the load on the
machine, avoid too long or oversize cutting line or cutting
on the heavy/woody shrubs.
Machine High-Temperature Protection
If the machine temperature exceeds 90°C during
operation, the temperature-protection circuit will
immediately shut off the machine from overheating
damage. The speed indicator will glow solid orange.
Release the trigger and wait until the overheated machine
cools down and the speed indicator turns green, then
restart the machine.
COMMUNICATION TECHNOLOGY
For information on our full range of connected products
and services, including connection instructions, please
scan the QR Code below or visit
www.egopowerplus.eu/connect.
12
56 VOLT LITHIUM-ION CORDLESS LINE TRIMMER — STX4500
Indicator Lights
Solid green
Solid orange
Flashing orange
The machine is working properly.
The machine is overheated. Cool the machine
until the temperature drops below 80°C. See "
Machine High-Temperature Protection " below.
The machine is overloaded. See "Machine
Overload Protection" below.
USING WITH LINE TRIMMER HEAD
WARNING:
To avoid serious personal injury, wear
goggles or safety glasses at all times when operating this
unit. Wear a face mask or dust mask in dusty locations.
Clear the area to be cut before each use. Remove all
objects, such as rocks, broken glass, nails, wire, or line
that can be thrown or become entangled in the cutting
attachment. Clear the area of children, bystanders,
and pets. At a minimum, keep all children, bystanders
and pets at least 15m away; there still may be risk to
bystanders from thrown objects. Bystanders should be
encouraged to wear eye protection. If you are approached,
stop the motor and cutting attachment immediately.
Before each use, check for damage/worn parts
Check the bump head, guard and loop handle and replace
the parts that are cracked, warped, bent, or damaged in
any away.
The line-cutting blade on the edge of the guard can
dull over time. It is recommended that you periodically
sharpen it with a file or replace it with a new blade.
After each use, clean the trimmer.
CAUTION:
Obstructions in the vents will prevent
the air from flowing into the motor housing and result in
overheating or damaged of the motor.
◾
Use only mild soap and a damp cloth to clean the
machine. Never let any liquid get inside the machine;
never immerse any part of the machine into a liquid.
Meaning
Publicidad
