ECOPOSTURAL C6981 Instrucciones página 17

English
supporting such a pressure and the table could consequently tilt over.
Caution! The back or feet section are aimed at leaning the back or feet respectively.
Never use these sections to lean forward or to sit down as the table could tilt over due
to an excessive pressure. The maximum weight support of every section is 50 kg.
c) HEIGHT adjustment
The central height of the table is operated by an electric motor.
To operate the supply cable must be plugged into a 220-230 V socket.
When raising or lowering the stretcher or when operating its modules, MAKE SURE
THAT NEITHER THE PATIENT NOR THE THERAPIST ARE TRAPPED between the
moving parts of the lifting mechanism by hands, feet or any other part of the body or
clothing. Be careful, since there is a risk of entrapment between mobile and fixed parts
of the stretcher, or, and due to unexpected movements when activating its modules.
Only operate the stretcher when there is no possibility that any part of the body could
be trapped and injured while moving the stretcher up/down or activating the tilt of the
component modules.
Pay special attention in the case of children and/or unauthorized personnel. Do not
leave children alone or unattended in the area around the stretcher.
Maintenance or cleaning tasks must be carried out only by authorized personnel and
with the stretcher drive systems properly blocked.
For adjusting the height use the foot pedal. Press the foot control switch pedal: left downwards / right
upwards.
When pressing the foot control, the table will take a moment to get up / down.
d) SECTIONS adjustment
The head-/backrest section is operated by a gas spring (3)
The central section is operated by a gas spring (3)
The feet section is operated by rack (2)
(2) Rack: Lift the section up to the required position and the rack will position itself automatically. To lower
the section, first raise it up to a certain extend or completely (as appropriate) in order to release the rack.
* The hinges on both sides must be properly fixed and positioned at the same height.
(3) Gas spring: Press the mechanism situated at the very edge of the section towards the upholstery and
the table section will go up slowly. Release mechanism to lock position. To lower the section, press the
mechanism with one hand and with the other hand, push the section downwards to the required position.
NEVER adjust any of the table sections WHILE THE PATIENT IS LEANING ON.
Safely position your FINGERS AND HANDS AWAY from the upholstery edge to avoid any
accidental jamming.
e) ACCESORIES Adjustment
How to adjust the articulated LEG SUPPORTS.
To adjust the height of the leg support, loose the black push-button lever to unlock the bar and move it up
or downwards to attain the required height or simply pull the bar out completely. Screw back on the lever to
lock.
To adjust the tilting of the leg support, loose the black lever under the support upholstery to unlock the
swivel plate. Next incline the leg support to the required position and screw back on the lever to lock.
* By pressing the push button of the lever you will be able to move the lever freely, no need to screw or
loose. This push button turns out to be very useful when the turning angle of the plastic levers is limited
due the short distance to the table frame.
3) MAINTENANCE
17