Kicker DX.5 Serie Manual De Instrucciones página 2

Authorized KICKER Dealer:
Purchase Date:
Model Number:
Serial Number:
PERFORMANCE
Model:
RMS Power, AMP1 and AMP2
@ 14.4V, 4 stereo,  1% THD+N
@ 14.4V, 2 stereo,  1% THD+N
@ 14.4V, 4 mono,  1% THD+N
RMS Power, SUB channel
@14.4V, 2 mono,  1.5 % THD+N
@14.4V, 4 mono,  1.5 % THD+N
Length, in. (cm)
Height, in. (mm)
Width, in. (mm)
Frequency Response ± 1dB
Signal-to-noise Ratio
Input Sensitivity
Selectable Electronic Crossover
Bass Boost
Subsonic Filter
Pro Tip: To get the best performance from your new KICKER Amplifi er and extend the warranty by 1 year, use
genuine KICKER accessories and wiring.
INSTALLATION
Mounting: Choose a structurally sound location to mount your KICKER amplifi er. Make sure there are no items
behind the area where the screws will be driven. Choose a location that allows at least 4" (10cm) of open
ventilation for the amplifi er. If possible, mount the amplifi er in the climate-controlled passenger compartment. Drill
four holes using a 7/64" (3mm) bit and use the supplied #8 screws to mount the amplifi er.
Wiring: Disconnect the vehicle's battery to avoid an electrical short. Then, connect the ground wire to the
amplifi er. Make the ground wire short, 24" (60cm) or less, and connect it to a paint-and-corrosion-free, solid,
metal area of the vehicle's chassis. Adding an additional ground wire of this same gauge (or larger) between the
battery's negative post and the vehicle chassis is recommended.
2
2011 DX 5-Channel Amps RevD.indd 2 2011 DX 5-Channel Amps RevD.indd 2
All manuals and user guides at all-guides.com
DX.5-SERIES AMPLIFIERS OWNER'S MANUAL
DX600.5
DX600.5
40W x 4
75W x 4
150W x 2
300 x 1
150 x 1
18-1/8" (46)
2-1/4" (57)
8-5/16" (211)
20Hz–20kHz
>95dB, A-weighted, re: rated power
Low Level: 125mV–5V
High Level: 250mV–10V
Variable HI or OFF (bypass), 50–200Hz, 12dB/octave;
Variable low-pass, 50–200Hz, 24dB/octave (SUB)
Variable 0–12dB @ 40Hz
24dB/Octave, Fixed @ 25Hz
11/3/2010 12:25:51 PM 11/3/2010 12:25:51 PM