Publicidad
Idiomas disponibles
Idiomas disponibles
ATTACHING HOSE
Insert the hose into the quick coupler already installed
on the compressor (Fig. 3).
WARNING:
Do not attach any tools to the open end of the hose until
start-up has been completed.
Firmly grasp the open end of the hose; hold facing
away from yourself and others.
WARMING UP THE COMPRESSOR
See Figures 3 - 5.
Check and tighten all bolts, fittings, etc.
Turn the pressure regulator knob fully clockwise to
open the air flow.
Place the switch in the OFF (O) position and plug in the
power cord.
Open the drain valve completely.
Turn the air compressor ON ( l ) and run the air
compressor for 30-40 seconds with drain valve open.
Place the switch in the OFF (O) position.
Close the drain valve.
Repeat this cold starting procedure prior to each use.
OVERLOAD PROTECTOR
This air compressor is equipped with a thermal overload
device which will turn the air compressor off automatically,
if the air compressor becomes overheated. If the motor
turns OFF repeatedly, check for the following possible
causes first: Low Voltage from the outlet. Lack of proper
ventilation or outside air or room temperature too high.
Extension cord too long or wrong gauge wire used.
To reset the air compressor:
Turn the air compressor off.
Unplug the air compressor and allow it to cool for 30
minutes.
Plug the air compressor into an approved outlet.
Turn the air compressor on.
ASSEMBLY
TANK
PRESSURE
GAUGE
REGULATOR
PRESSURE
GAUGE
DRAIN VALVE (closed)
12
PRESSURE
QUICK
REGULATOR
COUPLERS
KNOB
ON/OFF
SWITCH
DRAIN VALVE
(open)
SAFETY
VALVE
Fig. 3
Fig. 4
Fig. 5
Publicidad
