SICK G6L Instrucciones De Uso página 14

OPERATING INSTRUCTION
8 Disposal
en
9 Maintenance
14 O P E R A T I N G I N S T R U C T I O N | GSE6L
LED/fault pattern
Yellow LED lights up, no object
in the path of the beam
The sensor must be disposed of in line with applicable country-specific regulations.
When disposing of them, you should try to recycle them (especially the precious met‐
als).
NOTE
Disposal of batteries, electric and electronic devices
• According to international directives, batteries, accumulators and electrical or
electronic devices must not be disposed of in general waste.
• The owner is obliged by law to return this devices at the end of their life to the
respective public collection points.
•
WEEE: This symbol on the product, its package or in this document,
indicates that a product is subject to these regulations.
This SICK sensor is maintenance-free.
We do, however, recommend that the following activities are undertaken regularly:
• Clean the optical interfaces and housing
• Check the fittings and plug connectors
Cleaning
NOTICE
Equipment damage due to improper cleaning.
Improper cleaning may result in equipment damage.
Only use recommended cleaning agents and tools.
■
Never use sharp objects for cleaning.
■
Clean the optical surfaces at regular intervals and, in the event of contamination,
►
with a lint-free lens cloth (part number 4003353). The cleaning interval essentially
depends on the ambient conditions.
No modifications may be made to devices.
Subject to change without notice. Specified product properties and technical data are
not written guarantees.
Cause
The beam of light of a pho‐
toelectric through-beam sen‐
sor hits the receiver of
another (neighboring) photo‐
electric through-beam sensor
Measures
Swap the sender and receiver
arrangement at every sec‐
ond through-beam photoelec‐
tric sensor and ensure that
there is sufficient distance
between the through-beam
photoelectric sensors : see
figure 3, page 9
8025390.1NSI/2024-05-24 | SICK
Subject to change without notice