Publicidad
10
Preparing to install
• Adjustable headrest
• Shoulderbelt lock
• Shoulderbelt guide
• Lapbelt guider
• Reclining handles (2x)
• Base
• ISOfix release handle
• SIP bumper
• Height adjustment handles (2x)
• ISOfix connectors (2x)
• ISOfix release buttons (2x)
• ISOfix indicators (2x)
• ISOfix vehicle anchorage (2x)
• PAD+
• SIP+
Installation
1. When installing the seat in the front vehicle seat make sure the
backrest of the vehicle seat is in an upright position.
2. Position the seat inside the vehicle.
3. Pull the ISOfix release handle to release the ISOfix connectors. A
button on top of the handle will keep the handle in the released
position and locks the ISOfix connectors to slide in the base again. (2)
The ISOfix arms lock only in the position where it is totally extended.
In this locked position 2 red marks next to the button on the handle
will become visible. (3)
4. Click the ISOfix connectors to the ISOfix anchorage points in the
vehicle seat (4). Make sure that all ISOfix indicators are GREEN. (5, 6)
5. Press the button on top of the ISOfix release handle (located between
the red marks) down and push the handle back into the base. (7, 8)
Push the seat as far as possible towards the backrest of the vehicle
seat. (9)
6. Make sure the back of the seat is touching the backrest of the vehicle
seat. If the headrest of the vehicle is pushing the seat away from the
backrest, adjust the headrest.
7. If the seat cannot be used in combination with ISOfix anchorage
points in the vehicle seat, the ISOfix connectors can be stowed inside
the seat and the seat can be used in combination with the 3-point
belt only.
8. Slide the shoulderbelt in the shoulderbelt guide. (10) Make sure the
(1a)
(1b)
(1c)
(1d)
(1e)
(1f)
(1g)
(1h)
(1i)
(1j)
(1k)
(1l)
(1m)
(1n)
(1o)
Publicidad
