LaserLiner DigiLevel Pro 60 Instrucciones página 12

2
Switching on and measuring
!
Make sure that the reference function is deactivated before
measuring.
The DigiLevel Pro 40/60/80 can measure angles continuously to 360°.
– Switch the DigiLevel Plus on using the on/off switch (1).
– The slope angle is shown in the display (l). If slopes are measured
overhead, the direction of display adjusts automatically.
– The current slope direction is also shown by the symbol (a).
3 Selection of unit of measurement
Button (5) allows the desired unit of measurement to be selected
(° degrees, %, mm/m).
4 Calibration
1. Place the unit with its measuring edge (13) down on a straight
surface and mark the positions of the unit's ends on the under-
lying surface (see Fig. below). Switch on device (1). To access
calibration mode simultaneously press buttons 1 and 3.
-1- appears on the display.
2. Then press the READ button (1). -1- flashes.
The display then changes to -2-.
2 3 4 5 6 7 8 9 10 11
3. Now turn the unit around horizontally (end-for-end) by 180°
such that its ends are positioned opposite where they previously
were but again exactly at the underlying surface marks (reverse
measurement).
Then press the READ button (1) again. -2- flashes.
The subsequent acoustic signal concludes the process.
!
The unit is properly calibrated when it displays the same
measurement value, i.e. the underlying surface's deviation
from absolute level, in both positions (0° and 180°).
5 HOLD
Hold down the HOLD button (6) to keep displaying the current
measured value.
12
EN
READ
REF CAL
SET
12 13 14 15 16 17 18 19 20 21 22 23 24 25 26
DigiLevel Pro
%
mm/m
HOLD
27 28 29 30 31 32 33 34 35 36 37 38 39 40 41
WARNING
With magnet
on the bottom
42 43 44 45 46 47 48 49 50 51 52 53 54 55 56
LASERSTRAHLUNG!
NICHT IN DEN STRAHL BLICKEN!
LASERKLASSE 2 · < 1 mW · 635 nm
EN 60825-1:2014/AC:2017
LASER RADIATION! DO NOT STARE
INTO THE BEAM! CLASS 2 LASER
< 1 mW · 635 nm · EN 60825-1:2014/AC:2017
DigiLevel Pro 60
A quality product from
GmbH & Co. KG
Donnerfeld 2, 59757 Arnsberg
Germany, Tel: +49 2932 638-300
Fax: -333, www.laserliner.com
57 58