Installation Instructions /
5. Install the L brackets on the outer sill with the
short side of the bracket against the back of the
inner sill. Install one L bracket 7.5" to each side
of center line. See Fig. 5.
6. Carefully lift the air conditioner and slide it into
the open window. Make sure the bottom guide
of the unit drops into the notches of the L brackets.
When the air conditioner drops into the L brackets,
the air conditioner will be centered in window opening
as shown in Fig. 6.
While steadying the air conditioner, carefully bring
the window sash down behind the top channel
of the unit, as shown in Fig. 7.
Fix top channel to window sash with one 3/4"
screw, and fix side curtain frames with four 3/4"
screws as shown in Fig.6.
7. If storm window presents interference, fasten
a 2" wide wood strip to the inner window sill across
the full width of the sill. The wood strip should
be thick enough to raise the height of the window
sill.so that the unit can be installed without interference
from the storm window frame, as show in Fig. 8.
Top of wood strip should be approximately 3/4"
higher than the storm window frame to help
condensation to drain properly to the outside.
Install a second wood strip (approximately 17"
long by 1 i/
2
"wide and same thickness as first
strip) in the center of the outer sill flush against
the back of the inner sill.
Screw the L brackets into this strip, this will raise
the L bracket as shown in Fig. 8.
Inner Sill
Outer Sill
. •< >3«* Screw
Center Line
' W Sere*
Bradtet^xv^f
Short Side
**
;
Fig. 5
Fig. 6
Fig.8