Admiral AW-05CR1FHLU Manual De Uso Y Mantenimiento página 12

Operating Instructions /
► Mechanical control model
Power
ON will star the air conditioner.
OFF will completely shut-off the unit.
See Fig.9.
Fan Only
Rotate the knob dial to the Fan Only mark, the unit
will circulate the air without cooling.
See Fig.9.
Cooler
Rotate the knob dial to the Cooler marks, the unit
will circulate the air with cooling.
To set desired cooling temperature, simply rotate
the knob to the appropnate setting. The thermostat
will automatically controls the cooling cycle of the
air conditioner to maintain room temperature.
However, the fan motor will continue to operate after
the compressor is completed.
See Fig.9.
Thermostat knob
Fon Speed
1
LOW HI
1 1
1 1
1
OFF ON
_
t—
L
/
1
Power
Wolt Three Minutes
Before Restorting
i /
/ /
/ /
■fjT
V
switch
Fig.9
Fan Speed
LOW will circulate the air at a minimum speed with
cooling or not.Recommended for night-time use.
HI will circulate the air at a maximum speed with
cooling or not.
A CAUTION A
When using FAN control, turn slowly allowing
unit to adjust.
When using THERMOSTAT, be sure to allow
3 minutes before changing temperature.
Adjusting too quickly may cause an overload
resulting in a blown fuse.
NOTE: After setting the mode, allow 3 minutes
before switching to another mode.