Celexon CLR HomeCinema Performance UST Manual De Instrucciones página 19

STEP 2: MOUNTING THE FABRIC
Turn the frame round so that the front
is facing upwards, put on the enclosed
gloves on and slowly roll the cloth off
the roll over the frame.
Carefully centre the fabric over the en-
tire frame.
When attaching the fabric, start with
the opposite corners.
Use the press-in tool to press about
10 mm in on the vertical edge from the
corner of the groove (the cloth should
only snap into the first groove). Attach
first the four corner points A, then the
centre points B to position the cloth
and then the remaining edges C from
the centre outwards, to secure the fab-
ric completely.
If you notice that the cloth is not suf-
ficiently taut in some places after you
can press it down further with the
press-in tool to increase the tension of
the fabric.
If there are creases that cannot be
smoothed out, you can use the twee-
zers to lift the piping of the fabric at
each of the four corners and carefully
remove it using the press-in tool and
then press it back into place.
Front side
Smoothing and aligning
press
down
Starting
point
C
A B
A
C
C
B
C
A
A
B
C
press
down
Adjustment
Removing
the cloth
Press-in
tool
~10 mm
Initial installation
C
A
A
C
B
C
A
A
C
Press-in
tool
Align and lock
Tweezers
Dismantling the cloth
7