Descargar Imprimir esta página

AfG Berlin 74EGTT Esquema De Instalación página 22

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 43
REMINDERS FOR THE MAINTENANCE TECHNICIAN
The manufacturer will not be liable for any damage or
injury resulting from failure to observe the following
rules.
Read this manual carefully. It provides important
information for safe installation, use and maintenance of
the appliance.
Disconnect the appliance electrical power supply, if
present, before proceeding with any operation.
Installation, conversion to a different type of gas
and appliance maintenance must be carried out by
qualified technicians authorized by the manufacturer,
in compliance with current safety standards and the
instructions given in this manual.
Identify the specific appliance model. The model number
is detailed on the packaging and on the appliance data
plate.
The appliance must be installed in a well-ventilated
room.
Do not obstruct any air vents or drains present on the
appliance.
Do not tamper with appliance components
COMMISSIONING
Following installation or any maintenance operations, check
appliance operation. In the event of any malfunction, consult
the next paragraph "Troubleshooting".
ELECTRICAL APPLIANCES
Switch on the appliance as directed in the instructions and
reminders for use given in Chapter "INSTRUCTIONS FOR
USE" and check:
The current values of each phase.
The correct operation of the heating elements.
15. TROUBLESHOOTING
GLASS CERAMIC HOB
The radiant hotplate does not heat.
Possible causes:
Check the fuses.
Instructions for maintenance
Power supply main switch disconnected.
Insufficient voltage or incorrect electric connection of
the appliance.
Defective energy regulator.
Element defective or not properly connected
(burnt internal heating element).
Heating cannot be adjusted. Possible causes:
Temperature thermostat defective.
16. REPLACING COMPONENTS
REMINDERS FOR REPLACING COMPONENTS
Disconnect the appliance electrical power supply, if
present, before proceeding with any operation.
After replacing an electrical system component, check it
is correctly wired.
When replacing the radiant hotplates, handle and re-
assem-ble parts with the utmost care.
GLASS CERAMIC HOB
Replacing the radiant hotplates.
Remove the bottom of the appliance.
Remove and replace the faulty component.
Re-assemble all parts. For assembly, proceed in
reverse order.
Replacing the energy regulator.
Remove the bottom of the appliance.
Replace the faulty component.
Replacing the Glass ceramic hob.
In the event the glass ceramic hob is broken, contact
our company to have it replaced.
17. CLEANING THE INTERIOR
Check the condition of the inside of the appliance.
Remove any built-up dirt.
18. MAIN COMPONENTS
GLASS CERAMIC HOB
Glass ceramic hob.
Indicator light.
Radiant hotplates
Energy regulator.
23

Publicidad

loading

Este manual también es adecuado para:

78egtt74egtpt78egtpt70/40pve70/80pve