Makita XVJ05 Manual De Instrucciones página 7

To change the cutting action, turn the cutting action
changing lever to the desired cutting action position.
Refer to the table to select the appropriate cutting
action.
Position Cutting action
0 Straight line cutting
action
I Small orbital
cutting action
II Medium orbital
cutting action
III Large orbital
cutting action
Lighting up the front lamp
CAUTION:
Do not look in the light or see the
source of light directly.
To turn on the lamp, press the lock/unlock button. To
turn off the lamp, press the lock/unlock button again.
1
Fig.4
► 1 . Lamp 2. Lock/unlock button
NOTICE:
When the tool is overheated, the lamp
blinks. Cool down the tool fully before operating
the tool again.
NOTE: Use a dry cloth to wipe the dirt off the lens of
the lamp. Be careful not to scratch the lens of lamp, or
it may lower the illumination.
Switch action
To turn on the tool, press the lock/unlock button. The
tool turns into the standby mode. To start the tool, press
the start/stop button in the standby mode. To stop the
Applications
tool, press the start/stop button again. The tool turns
For cutting mild
into the standby mode. To turn off the tool, press the
steel, stainless
lock/unlock button in the standby mode.
steel and plastics.
For clean cuts in
wood and plywood.
For cutting mild
steel, aluminum
and hard wood.
For cutting wood
and plywood.
For fast cutting in
aluminum and mild
steel.
For fast cutting in
wood and plywood.
Fig.5
► 1 . Lock/unlock button 2. Start/stop button
NOTE: If the tool is left for 10 seconds without any
operation in the standby mode, the tool automatically
turns off and the lamp goes off.
NOTE: You can also stop and turn off the tool by
pressing the lock/unlock button while the tool is
operating.
To decreases the brightness of the lamp, press and hold
the lock/unlock button when turning into the standby
mode. About 1 second after you start pressing the lock/
unlock button, the brightness of the lamp will start to
decrease, so release the lock/unlock button when you
reach the desired brightness. It turns the tool into the
standby mode, too. About 3 seconds after you start
pressing the lock/unlock button, the brightness of the
2
lamp will be minimized and the brightness will not
change after that.
NOTE: The brightness of the lamp cannot be
adjusted while the tool is in standby mode. To adjust
the brightness of the lamp, turn off the tool.
NOTE: There is no memory function for the bright-
ness of the lamp. If you turn the lamp off and then turn
it on, the brightness of the lamp will be maximized
each time.
7 ENGLISH
1
2