Makita XVJ05 Manual De Instrucciones página 9

Before installing the jig saw blade, make sure that the
blade clamp lever is in the released position.
To install the jig saw blade, insert the jig saw blade
(teeth facing forward) into the jig saw blade holder. The
blade clamp lever moves to the fixed position and the
jig saw blade is locked. Make sure that the back edge
of the jig saw blade fits into the roller. Pull the jig saw
blade lightly to make sure that the jig saw blade does
not fall off during operation.
1
2
Fig.7
► 1 . Jig saw blade holder 2. Blade clamp lever
(released position) 3. Blade clamp lever (fixed
position)
1
2
Fig.8
► 1 . Jig saw blade holder 2. Jig saw blade 3. Roller
CAUTION:
If the blade clamp lever does not
move to the fixed position, the jig saw blade is
not installed completely. Do not press the blade
clamp lever by hand to the fixed position. It may
damage the tool.
To remove the jig saw blade, push the blade clamp lever
forward as far as it will go. This allows the jig saw blade
to be released.
Fig.9
► 1 . Jig saw blade holder 2. Blade clamp lever 3. Jig
saw blade
NOTE: If it is difficult to remove the jig saw blade, turn
3
the cutting action changing lever to the position "III"
and move the jig saw blade holder to the bottom. To
move the jig saw blade holder to the bottom, return
the blade clamp lever fully to the fixed position once
and slightly switch on the tool several times.
NOTE: Occasionally lubricate the roller.
Hex wrench storage
When not in use, store the hex wrench as shown in the
figure to keep it from being lost.
1
Fig.10
► 1 . Hex wrench
3
9 ENGLISH
2
1
3