TJ Aire Serie Guía Rápida De Usuario página 32

CLEANING THE BRAZIER AND BRAZIER HOLDER
According to the quality of the fuel, crusts may form that hinder the correct operation of the heater, meaning that they
should be removed from the brazier.
Lift the brazier up and clean these crusts and remove the ash, always taking care to unblock any holes that may have
become blocked.
CLEANING THE HEAT EXCHANGER
This is a simple task that does not require any special tools but it does ensure that your heater has an effective heat
exchanger for the heat from the unit with the air in the room. The work must be carried out when the heater is coold
and it may be convenient to do so before each lighting or at least on a daily basis. To carry out the cleaning, pull the
rod forwards and backwards, which makes a grate move that cleans the heat exchanger, removing any residues
from combustion and thus ensuring peak performance.
CLEANING THE INTERIOR OF THE COMBUSTION CHAMBER
Follow the steps as indicated in the following images, take special care with the insulator that you will find behind the front vermiculite, this is an insulating material, which should be replaced if
it is not in optimal condition.
CLEANING THE GLASS
Regularly clean the glass door of the heater with a degreasing product (not one that is corrosive or abrasive).
If the glass is still warm, leave the door open before cleaning for as long as the heater requires to cool down. Do not use
materials that could damage or scratch the glass.
CLEANING THE ASH DRAWER
The ash collection drawer surrounds the brazier holder, which must be regularly emptied to prevent it overflowing
with ashes. The ashes must be placed in a metal container with a sealed lid until the ashes are wholly and completely
extinguished. The closed contained must be placed on a non-flammable base or the ground and well away from
flammable materials. Once the ash drawer has been emptied, put it back in its position.
UNPRESS THE DOOR CLOSURE CORD
It is advisable that the cord be stretched monthly in the months of use of the device to avoid problems when not being properly flattened
due to use, causing problems of not adjusting the door correctly when closing, causing problems such as lack of flow for startup or during
operation.
By running your finger and releasing the cord a bit both from the top and the bottom we will avoid these possible incidents caused by the
use of the device.
32 32
EN