Publicidad
Idiomas disponibles
Idiomas disponibles
Cleaning and maintaining the
safety cutter bar
Tools and aids required
• Cloth
• Care oil spray
Care after each use
• Remove any green cuttings that are
stuck.
• Clean the safety cutter bar (2) with an
oily cloth.
• Maintain the safety cutter bar (2) with
a care oil spray.
Maintenance and repair
• Check the device before each use for
obvious defects such as loose, worn or
damaged parts. Ensure that the screws
in the safety cutter bar (2) are firmly in
place.
• Check the covers and protective
devices (1/2/3) for damage and cor-
rect fit. Replace these if necessary or
have them repaired by the service
centre.
• You can smooth out slight nicks on the
cutting teeth yourself. To do this, pull
off the cutting edges with an oil stone.
Only sharp cutting teeth provide a
good cutting performance.
• Blunt, bent or damaged safety cutter
bars must be replaced.
Have any work that is not described in this
instruction manual performed by our ser-
vice centre. Only use original parts.
Storage
Always store the device:
• clean
• dry
• protected against dust
• in the blade encasing (13)
• out of the reach of children
The storage temperature for the re-
chargeable battery and the device is
between 0°C and 45°C. Avoid extreme
cold or heat during storage to ensure the
battery output is not adversely affected.
Remove the rechargeable battery from the
device before storing the device (see the
separate operating instructions for the bat-
tery and charger).
Maintenance
Tools and aids required
• Hand protection (3, Spare parts and
accessories, p. 44)
• Phillips screwdriver (not included)
Replacing the hand protection
(Fig. B)
1. Loosen the two screws (22) on the
hand protection (3) with a screwdriver.
2. Replace the damaged hand protection
(3).
3. Fasten the new hand protection (3)
with the two screws (22).
PARKSIDE app
The PARKSIDE app lets you monitor the
device and control certain functions. The
functions may change with updates to the
app and firmware. For more information
on the PARKSIDE app, see the instructions
for the smart battery.
Requirements
To find the device in the PARKSIDE app,
the following requirements must be met:
• The PARKSIDE app is installed on your
smartphone and Bluetooth® is activ-
ated.
• The following battery is inside the
device: PARKSIDE Performance Smart
battery PAPS 204 A1 or PAPS 208 A1.
This battery is already connected to the
PARKSIDE app.
GB
MT
39
Publicidad
