Publicidad
Idiomas disponibles
Idiomas disponibles
Troubleshooting
The following table will assist you in fixing faults:
Problem
Device does not start
Device works with interrup-
tions
Safety cutter bar (2) be-
comes hot.
Bad cutting results
Disposal/
environmental
protection
Remove the battery from the device and
recycle the device, battery, accessories
and packaging in an environmentally-
friendly manner.
Possible cause
Rechargeable battery (9) not
inserted
Rechargeable battery (9) dis-
charged
Safety switch (21) or On/
Off switch (7) defective.
Defective motor
Internal loose contact
Safety switch (21) or On/
Off switch (7) defective.
Safety cutter bar (2) blunt
Nicks on safety cutter bar
(2).
Too much friction due to lack
of lubrication
Too much friction due to lack
of lubrication
Safety cutter bar (2) blunt
Safety cutter bar dirty
Bad cutting technique
The symbol of the crossed-out wheeled bin
means that this product must not be dis-
posed of as unsorted municipal waste at
the end of its useful life.
Error correction
Inserting the batteries ,
p. 37
Charge the battery (see the
separate operating instruc-
tions for the rechargeable
battery and charger)
contact the service centre.
contact the service centre.
Have the safety cutter bar
sharpened or replaced (ser-
vice centre)
Lubricate the safety cutter
bar (2)
Lubricate the safety cutter
bar (2)
Have the safety cutter bar
sharpened or replaced (ser-
vice centre)
Clean the safety cutter bar
See Cutting techniques,
p. 36
Electrical devices must not be dis-
posed of with domestic waste.
GB
MT
41
Publicidad
