Publicidad
Lift Agitator Up
Soulever l'agitateur
Levantar el agitador
Motor Shaft
Arbre d'entraînement
du moteur
Eje del motor
Agitator Pulley
Poulie de l'agitateur
Polea del agitador
Groove
1
Ouverture
Ranura
2
Agitator Clutch Fork
Fourchette d'embrayage
de l'agitateur
Clutch del agitador
Replacing Belt
End Cap
Bouchon
Tapa de
extremo
3
End Cap
Bouchon
Tapa de
extremo
Groove
Ouverture
Ranura
- 30 -
➢ ➢ Replace belt whenever a burning
rubber smell caused by excessive
belt slippage occurs.
➢ ➢ Remove lower plate. See: "Removing
and Installing Lower Plate"
➢ ➢ Remove agitator by carefully lifting
out.
➢ ➢ Remove worn or broken belt.
➢ ➢ Clean agitator. See: "Cleaning
Agitator"
➢ ➢ Loop new belt (Panasonic Type UB8
only) around motor shaft and
agitator pulley; see illustration for
correct belt routing.
➢ ➢ Reinstall agitator clutch fork into the
agitator end cap.
➢ ➢ Reinstall agitator back into nozzle
housing grooves.
➢ ➢ After reinstalling the agitator, turn it
by hand to make sure the belt is not
twisted or pinched and that all
rotating parts turn freely.
➢ ➢ Reinstall lower plate. See:
"Removing and Installing Lower
Plate"
Publicidad
