AEG BSE77228BM Manual De Instrucciones página 100

BEFORE FIRST USE
Remove all accessories and
removable shelf supports from
the oven.
5.2 First connection
The display shows welcome message after the first connection.
You have to set: Language, Display brightness, Key tones, Buzzer volume, Water hardness,
Time of day.
5.3 Initial preheating
Preheat the empty oven before the first use.
Step 1 Remove all accessories and removable shelf supports from the oven.
Step 2
Set the maximum temperature for the function:
Let the oven operate for 1 h.
Step 3
Set the maximum temperature for the function:
Let the oven operate for 15 min.
The oven can emit an odour and smoke during preheating. Make sure that the room is ventila‐
ted.
5.4 How to set: Water hardness
When you connect the oven to the mains you have to set the water hardness level.
Use the test paper or contact your water supplier to check the water hardness level.
Step 1
Put the test paper
into water for about
1 sec. Do not put
the test paper under
running water.
The colours of the test paper continue to change. Do not check water hardness later than 1
min after test.
100/312
Clean the oven and the ac‐
cessories with a soft cloth,
warm water and a mild deter‐
Step 2
Shake the test paper
to remove the excess
of water.
gent.
.
.
Step 3
After 1 min, check
water hardness with
the table below.
Place the accessories and the
removable shelf supports in
the oven.
Step 4
Set the water hardness
level: Menu / Settings /
Setup / Water hard‐
ness.