Publicidad
Idiomas disponibles
Idiomas disponibles
m
WARNING! Risk of fire! Fit the
product so that it is at least 1 m away
from the material to be illuminated .
Excessive heat can result in a fire .
The product is only suited for use with the
built-in LED control gear .
The product continues to draw a small amount
of power even if the product is off as long
as the product is connected to the supply
mains . To switch the product off completely,
disconnect the power plug
outlet .
Luminaries shall not be connected after each
other .
This is not a portable lamp . Disconnect the
power plug
from the socket-outlet before
11 ]
[
moving the tripod .
˜ Before installation
NOTE: Remove all packaging materials from
the product .
The product may be placed on the provided
tripod
and then be positioned in the
[
9 ]
desired location .
Rotate the locking screw
loosen the tripod
[
9 ]
Adjust the tripod
[
9 ]
Rotate the locking screw
the tripod in its position (fig . B) .
Use and operate the product on a stable
surface without any angle .
Fully extend the tripod
stability of the product .
CAUTION! Note the position of your hands
m
whilst opening or closing the tripod
pinching your fingers (fig . A) .
16 GB/IE
from the socket-
11 ]
[
anti-clockwise to
10 ]
[
(fig . B) .
to the desired position .
clockwise to fix
10 ]
[
and check the
[
9 ]
. Risk of
9 ]
[
˜ Installation
Attaching the baseplate
(fig . C):
–
Turn the tripod locking screw
clockwise direction to loosen it completely .
As the tripod locking screw loosens, the
spring washer
7 ]
[
with it .
–
Fasten the baseplate
with the tripod locking screw
washer
and flat washer
[
7 ]
tripod locking screw clockwise until fully
tightened .
Attaching the spotlights
baseplate
(fig . C):
5 ]
[
–
Turn the spotlight fixing screws
anti-clockwise direction to loosen them
completely . As the spotlight fixing screws
loosen, the washers
nuts
loosen with it .
4 ]
[
–
Secure the spotlight brackets
baseplate
with the spotlight fixing
[
5 ]
screws
, washers
[
2 ]
nuts
. Turn the spotlight fixing screws
[
4 ]
clockwise until fully tightened .
to the tripod
5 ]
[
[
9 ]
in an anti-
[
6 ]
and flat washer
loosen
[
8 ]
to the tripod
[
5 ]
[
9 ]
, spring
[
6 ]
. Turn the
8 ]
[
to the
[
1 ]
in an
[
2 ]
and spotlight
3 ]
[
to the
12 ]
[
and spotlight
3 ]
[
Publicidad
