FAAC TM2 45 PPR Manual De Instrucciones página 17

ASSEMBLING THE MOTOR
RING NUT
1
2
3
NB: If the tube has a circular section, the drive pulley must be fastened to the tube.
This must be carried out by the installer. For other types of profile, it is optional to
fasten it to the tube, even if it is strongly recommended to do so.
TM2 PPR
RING NUT ADAPTER
17
DRIVE PULLEY
1. Insert the adapter onto the ring nut
so that the groove is lined up with the
reference mark and push it on as far as
it will go.
2. Install the drive pulley on the shaft of
the motor until the detent spring clicks.
3. Insert the motor completely into the
winding tube.
A4518_6G85_Rev.A