Publicidad
Idiomas disponibles
Idiomas disponibles
To achieve better extraction, we recommend
switching on the extractor a few minutes
before starting to cook (3 - 5 minutes) so that
the air flow is continuous and stable when
extracting the fumes.
Likewise, keep the extractor switched on for a
few minutes when cooking is complete to
allow all fumes and odours to be expelled.
Operating settings
1. When the tray is opened, the hood starts
operating at the last speed, depending on
how it was used the last time.
2. To increase speed gradually, press the
maximum speed is set.
3. The sixth speed is timed, so the cooker
hood will automatically reduce speed after
seven minutes.
4. To reduce the speed gradually, press the
5. To turn off the cooker hood directly at any
seconds.
Programming stop delay timer
1. Programming Timer
a. Open Tray with motors switched on or off
Before
carrying
maintenance
activities,
extractor is disconnected from the mains.
To carry out cleaning and maintenance, follow
the Safety Instructions.
Fire risk exists in case that cleaning does not
take place according to the instructions.
Filter cleaning
To withdraw the filters from their locations
release the anchoring points. Clean the filter,
either by putting it in the dishwasher (see
24
out
any
cleaning
ensure
that
b.
flicker quickly.
c.
aspiration time. Each LED represents 5
minutes of operating time. The maximum
operating time is 30 minutes (the LED
corresponding to the intensive speed starts
flickering fast).
d. 5 seconds after pressing the keys, the LED
corresponding to the time stops flickering
fast and the LED corresponding to the
selected speed starts flickering slowly.
e. In stop delay timer Mode, speed can be
2. Cancellation of Stop Delay Timer:
switch off or close the tray.
Lighting
The lighting can be switched on and off by
When tray is opened, the lighting is switched
on or off, depending on how it was used the
last time.
or
notes) or leaving it standing in hot water to
the
simplify the removal of grease or, if wished, by
means of special sprays (protecting the non
metallic parts). Once clean, leave it to dry.
To replace the filters, proceed in the reverse
way to their removal. Make sure that the filter
latch is securely attached to the housing to
prevent untimely drops of the filters.
Attention: the cooker hood will not work until
the main filter was reinstalled.
Notes: cleaning in the dishwasher with
aggressive
pressed until all LEDs
detergents
may
blacken
the
Publicidad
