Parkside PWD 25 C4 Traduccion Del Manual De Instrucciones Originale página 27

You will hear the lock click into place.
Attaching the suction hose (Fig. A)
1. Press and hold the lock (20) on the
suction hose (19).
2. Pull the suction hose (19) out of the
connector.
Attaching and removing the
filter and filter bag
Overview
The appliance has the following filters and
bags:
• Pleated filter (25)
• Dry vacuuming
• Use an additional paper filter bag
so that the pleated filter does not
clog up so quickly.
• Filter cleaning button, p. 29
• Foam filter (23)
• Wet vacuuming
• Paper filter bag (26)
• Dry vacuuming
• Fine dust filter bag
• Vacuuming fine dust
• available as accessories
Disassembling the pleated filter
(Fig. C)
1. Remove the motor head (3).
Place the motor head (3) with the top
facing downward.
2. Unlock the lock (24) of the pleated fil-
ter (25).
3. Remove the pleated filter (25).
Assembling the pleated filter
(Fig. C)
1. Remove the motor head (3).
Place the motor head (3) with the top
facing downward.
2. If necessary, remove the foam filter
(23).
3. Place the pleated filter (25) over the fil-
ter basket (30).
4. If the pleated filter (25) is not imme-
diately in place, turn the lock until the
pleated filter moves with the direction
of the motor head (3).
5. Lock the lock (24) of the pleated filter
(25).
6. Mount the motor head.
Installing the filter bag (Fig. D)
These instructions apply for the paper fil-
ter bag (26) and the fine dust filter bag
(available as accessories).
1. Remove the motor head (3).
Place the motor head (3) with the top
facing downward.
2. Inside the dirt container (10), pull the
filter bag over the suction connector
(14). The sealing ring on the filter bag
opening must fully surround the con-
nector on the suction connector.
3. Mount the motor head.
Removing the filter bag (Fig. D)
1. Remove the motor head (3).
Place the motor head (3) with the top
facing downward.
2. You can remove the filter bag.
3. Mount the motor head.
Removing the foam filter (Fig. C)
1. Remove the motor head (3).
Place the motor head (3) with the top
facing downward.
2. Carefully remove the foam filter (23).
Installing the foam filter (Fig. C)
Only insert a dry filter.
1. Remove the motor head (3).
Place the motor head (3) with the top
facing downward.
2. Roll the foam filter (23) up a bit.
3. Pull the foam filter over the filter basket
(30).
4. Roll the foam filter so that it is smooth.
GB MT
27