Parkside PUB 150 A1 Traduccion Del Manual De Instrucciones Originale página 18

GB MT
Extent of the delivery
Carefully­unpack­the­trimmer­and­check­
that it is complete. Dispose of the packag-
ing material correctly.
•­ Device­
•­ 1­x­metal­brush
•­ 1­x­nylon­brush
•­ Instruction­Manual
Functional description
The­hand-held­universal­brush­uses­an­
electric motor as a drive.
A metal brush or a nylon brush can be
used for cleaning joints and surfaces,
depending on the requirements.
Please refer to the descriptions below for
information about the operating devices.
Survey
1 Handle
­ 2­ On/Off­switch
3 Strain relief
4 Power cord
5 Grip piece
6 Phillips screw
­ 7­ Centerpiece
8 Splash guard
9 Nylon brush
­ 10­ Center­piece
11 Guide roller
­ 12­ Auxiliary­handle
13 Metal brush
14 Brush support
Technical data
Electric multi-purpose brush ... PUB 150 A1
Motor voltage
U 230-240­V~­(alternating­current),­50­Hz
Power P ..................................... 150 W
18
Protection class .................................
Protection category...........................IPX0
Idling speed n .................... 1300 min
max
Weight­(without­bristles) .... approx.­1.3­kg
Weight­(only­bristles) ...... approx.­0.25­kg
Sound pressure level
(L ) .................. 70.3­dB(A);­K
pA
Sound­power­level­(L
measured ..... 81.6­dB(A);­K
guaranteed ........................... 84 dB(A)
Vibration­(a )
h
additional
handle ............ 1.54 m/s
handle ............ 1.32 m/s
Noise and vibration values have been
determined according to the standards and
regulations mentioned in the declaration of
conformity.
Wear hearing protection.
The­specified­total­vibration­value­and­the­
stated noise emission value were measured
according to a standardized test method
and can be used to compare one power
tool with another.
The­specified­total­vibration­value­and­the­
stated noise emission value can also be
used for provisional assessment of the load.
Warning: The vibration and noise
emissions may deviate from the
specified­values­during­actual­use­of­the­
power tool, depending on how the power
tool is being used and, in particular, what
kind of material is being worked on.
It is necessary to establish safety measures
to protect the operator based on estimated
vibration­exposure­during­actual­conditions­
of­use­(all­parts­of­the­operating­cycle­must­
be­considered­while­doing­so,­for­example,­
times when the power tool is turned off and
times­when­it­is­turned­on­but­running­idle).­
= 3 dB
pA
)
WA
= 1.97 dB
WA
;­K=­1,5 m/s
2
;­K=­1,5 m/s
2
II
-1
2
2