Parkside PUB 150 A1 Traduccion Del Manual De Instrucciones Originale página 23

Inserting/exchanging
the brush
Inserting a brush
1. Push­the­brush­support­(
center­piece­(10).
2. Keep pressure on the brush support
( 14 ).
3.­Insert­the­desired­brush­(9/13)­into­the­
brush­support­(
14
4.­Push­the­brush­(9/13)­into­the­brush­
support­( )­toward­the­center­piece­
14
(10).
5.­Release­the­brush­support­(
Exchanging the brush
1. Push­the­brush­support­(
center­piece­(10).
2. Keep pressure on the brush support
( 14 ).
3.­Remove­the­brush­(9/13).
4.­Insert­the­desired­brush­(9/13)­into­the­
brush­support­(
14
4.­Push­the­brush­(9/13)­into­the­brush­
support­( )­toward­the­center­piece­
14
(10).
5.­Release­the­brush­support­(
Operation
Caution, risk of Injury!
Always check whether the
device functions correctly be-
fore using it.
Always wear eye protection
when operating the device.
Always unplug the device be-
fore working on it. There is a
risk of injury.
­ Observe­the­noise­protection­and­
other local regulations. .
14 )­toward­the­
).
14 ).
14 )­toward­the­
).
14 ).
Switching ON and OFF
1.­ Loop­the­end­of­the­extension­cable­
and hang it onto the cable tension re-
lief­(3)­to­ease­the­tension­on­the­cable.­
2. Plug the tool into the mains.
3.­ Press­the­On/Off­button­(2)­to­switch­
on the device.
4.­ To­turn­off,­release­the­On/Off­switch­
(2).­There­is­no­continuous­operation­
mode.
The brush will keep rotating for a
few seconds after the device has
been switched off. Keep the brush
away from hands and feet.
Do not try to lock the on/
off switch in place. Do not
use the device if the switch is
damaged. A damaged switch
may cause an injury risk
due to the motor not being
switched off after releasing
the on/off switch.
Practical tips
Caution,
risk of Injury!
•­ Always­inspect­the­brush­before­start-
ing the device. Never use damaged
brushes. Replace any damaged or
worn brush.
•­ Use­original­brushes­only.
•­ Never­operate­the­device­in­rain­or­on­
wet­ground.­Operating­the­device­in­
rain or on wet ground can cause an
electric shock.
•­ Always­move­across­the­slope­when­
working on hills.
•­ Avoid­any­contact­with­fixed­obstacles­
(rocks,­walls,­picket­fences,­etc.)­in­or-
GB MT
23