Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
Drilling in Wood
Holes in wood can be made with the same twist drill bits
used for metal or with spade bits. These bits should be
sharp and should be pulled out frequently when drilling to
clear chips from the flutes.
Drilling in Metal
Use a cutting lubricant when drilling metals. The exceptions
are cast iron and brass which should be drilled dry. The
cutting lubricants that work best are sulfurized cutting oil
or lard oil.
LED Work Light
When drill is activated by pulling the variable speed
trigger switch
1
, the integrated LED work light
automatically illuminate the work area.
NOTE: The work light is for lighting the immediate work
surface and is not intended to be used as a flashlight.
Bit Tip Storage
A bit storage slot ( 10 ) is built into the base of the tool.
MAINTENANCE
Your BLACK+DECKER tool has been designed to operate
over a long period of time with a minimum of maintenance.
Continuous satisfactory operation depends upon proper
tool care and regular cleaning. Your charger does not
require any maintenance apart from regular cleaning.
WARNING: To reduce the risk of serious personal
injury, turn off the tool and disconnect it from
the power source before making adjustments or
removing / installing devices or accessories. An
accidental start could cause injuries.
¡Important! To ensure product SAFETY and
RELIABILITY, repairs, maintenance and adjustment
(other than those listed in this manual) should be
performed by authorized service centers or other qualified
organizations, always using identical replacement parts.
Unit contains no user service able parts inside.
CLEANING
WARNING: Blow dirt and dust from all ventilation
ducts with dry air, at least once a week. To reduce
the risk of injury, always use ansi z87.1 Approved eye
protection when performing this task.
WARNING: Never use solvents or other abrasive
chemicals to clean non-metallic parts of the tool. These
chemicals can weaken the plastic materials used in these
parts. Use a cloth dampened only with water and neutral
soap. Never allow liquid to penetrate inside the tool or
immerse any of the parts in a liquid.
30
ACCESSORIES
Recommended accessories for use with your tool are
available at extra cost from your local dealer or authorized
service center.
WARNING! The use of any accessory not recommended
for use with this tool could be hazardous.
PROTECTING THE ENVIRONMENT
7
will
BATTERIES
•
Run the battery down completely, then remove it from
the tool.
•
NiCd, NiMH and Li-Ion batteries are recyclable. Take them
to any authorized repair agent or a local recycling station.
TECHNICAL DATA
CORDLESS DRILL/DRIVER
Voltage
Speed ranges
No-load
speed
Chuck
Torque
Torque positions
Drilling capacity
Wood
Steel
Weight
(tool only)
Separate collection. This product must not be
disposed of with normal household waste. Should
you find one day that your BLACK+DECKER product
needs replacement, or if it is of no further use to you,
do not dispose of it with household waste. Make
this product available for separate collection.
Separate collection of used products and packaging
allows materials to be recycled and used again.
Re-use of recycled materials helps prevent
environmental pollution and reduces the demand
for raw materials. Local regulations may provide for
separate collection of electrical products from the
household, at municipal waste sites or by the
retailer when you purchase a new product.
BLACK+DECKER batteries can be recharged many
times. At the end of their useful life, discard
batteries with due care for our environment:
.../min
(rpm)
in (mm)
Nm (in-lb)
in (mm)
in (mm)
lbs (kg)
BCD703
20 V
MAX*
2
0 - 360 / 0 - 1400
3/8 (10)
38 (336.3)
10+1**
1 (25)
3/8 (10)
1.9 (0.9)
Publicidad
