Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATING INSTRUCTIONS
1.
Plug the power cord into a suitable socket.
2.
Oscillation: To make the fan head oscillate, push down the oscillation knob. To stop the fan head from
oscillating, pull up the oscillation knob.
3.
Tilting Angle: The fan head can lean slightly backwards in a tilt angle from 0° to 10° (See below drawings for
reference.). Just loosen anticlockwise the knob for adjusting tilt of fan head (3) and the screw for fixing tilt
of fan head (4), push the fan guard and make the fan head lean back to your desired angle within the tilt
range, then tighten clockwise the knob for adjusting tilt of fan head (3) and the screw for fixing tilt of fan
head (4).
Tilting angle – 0°
4.
The fan is switched on by turning the speed control switch, i.e. O = OFF, I = low Speed, II = medium Speed,
III =high speed.
CLEANING
1.
Before servicing the fan and after each occasion of use, switch off the appliance and unplug the mains
cable from the socket.
2.
Never immerse the appliance in water (danger of short-circuit). To clean the appliance, only wipe it down
with a damp cloth and dry it carefully. Always take out the mains plug first.
3.
Take care that excessive dust does not build up in the air-intake and air-outlet grille, and clean it
occasionally using a dry brush or vacuum cleaner.
TECHNICAL DATA
Operating voltage: 220-240V ~ 50/60Hz
Power consumption: 50W
Recycling – European Directive 2012/19/EU
This marking indicates that this product should not be disposed with other household wastes. To
prevent possible harm to the environment or human health from uncontrolled waste disposal,
recycle it responsibly to promote the sustainable reuse of material resources. To return your used
device, please use the return and collection systems or contact the retailer where the product was
purchased. They can take this product for environmental safe recycling.
- 11 -
Tilting angle – 10°
FN-114501.4 / FN-114501.7
Publicidad
