Balluff BTL7-S5 Serie Instrucciones Breves página 4

BTL7-S5 _ _ D-M _ _ _ _ -TK 2/3-S32/KA _ _ /FA _ _
Magnetostrictive Linear Position Sensor – Rod Style
The CE Mark verifies that our products
meet the requirements of the current
EMC Directive.
Intended use
The BTL magnetostrictive linear position sensor, together
with a machine controller (e.g. PLC), comprises a position
measuring system. It is intended to be installed into a
machine or system and used in the industrial sector.
Flawless function in accordance with the specifications in
the technical data is ensured only when using original
Balluff accessories. Use of any other components will void
the warranty.
Opening the BTL or non-approved use are not permitted
and will result in the loss of warranty and liability claims
against the manufacturer.
General safety notes
Installation and startup may only be performed by
trained specialists.
The operator is responsible for ensuring that local safety
regulations are observed. In particular, the operator must
take steps to ensure that a defect in the BTL will not result
in hazards to persons or equipment.
If defects and unresolvable faults occur in the BTL, take it
out of service and secure against unauthorized use.
Downloading further instructions
A complete user's guide can be downloaded from the
Internet at www.balluff.com or requested via e-mail from
service@balluff.de. The technical data can be found in
the guide for the BTL7-...-TB... For deviating technical
data for use with an adapter, please see the separate
adapter instructions.
BTL7-TK-Cable BTL7-TK-S32
Ø max. 7
~20
12.5
Unusable area
2)
Not included in scope of delivery
3)
4) Ø 6.1 for hook spanner Ø 74
5) Not mounted
1 english
Mounting surface
TK:
40-1 mm
2)
Magnet
4)
34
~80 25
Adapter
BAM AD-TL-012-B/K-4
(M18×1.5 on Ø18h6)
Dimensions and function
The BTL contains the waveguide which is protected by an
outer stainless steel tube (rod). A magnet is moved along
the waveguide. This magnet is connected to the system
part whose position is to be determined.
The magnet defines the position to be measured on the
waveguide.
LED Operating state
Normal function
Green
Magnet is within the limits.
Programming mode
Flashing
Green BTL is in programming mode.
Error
Red
No magnet or magnet outside the limits.
Flashing Clock signal missing
Red No internal measurement is triggered.
1)
Not for BTL7-...FA_ _
Installation
NOTICE
Interference in function
Improper installation can compromise the function of the
BTL and result in increased wear.
► The mounting surface of the BTL must make full
contact with the supporting surface.
► The bore must be perfectly sealed (O-ring/flat seal).
Adapter can be used with all BTL that have an M18 thread.
For secure fastening, tighten the adapter with the enclosed
cylinder screws (ISO 4762, M6×16 - A4-80) at all
6 mounting holes.
Damping zone
Nominal length =
60
Measuring range
3)
Ø18h6
5)
Top view of the
BTL7-...-TK2-S32, with
dummy plug
File no.
E227256 1)
2)
TK3
LED
Ø 74
Ø 79