Publicidad
Idiomas disponibles
Idiomas disponibles
2. Remove the grass collection basket (5) (if used) by
the carrying handle (5a).
3. Lift the discharge flap (8) and insert the mulching in-
sert (13).
4. Adjust the cutting height (see 9.1).
Note:
Cut the grass back by 2 cm if the grass is 4-6 cm high.
10.2.2
Difference between lawn mowing and
lawn mulching (Fig. 13, 16)
When using the mulching insert (13), the grass clippings
are not collected in a grass collection bag, but shredded
and distributed over the lawn. The nutrients contained in
the grass clippings are thus broken down by soil organ-
isms forming a nutrient cycle. Mulched lawns therefore
need to be fertilised much less frequently.
As a general rule, the lawn must be mowed relatively of-
ten so that only small amounts of mulch remain on the
lawn. It is therefore best to mulch the lawn at least once a
week and set the mower so that only approx. 40% of the
total height of the lawn is mulched. If the mulch remains
visible on the lawn (e.g. during the first cut of the year or
during heavy growth), the grass bag (5) should be used.
10.3
Safety key (14) (Fig. 1, 17)
Note:
The product can only be started if the security key is in-
serted in the product.
1. Open the cover (7).
2. Insert the rechargeable batteries (17) as described in
9.2.
3. Insert the safety key (14).
4. Close the cover (7).
WARNING
Danger of injury!
To switch off the product, switch off the motor, wait for it
to stop, remove the battery and pull out the safety key.
10.4
Blade-stop device (Fig. 1, 18)
Before each use, you must check the blade stop device.
Start the motor as described in 10.5.
1. Release the safety bar (1). The engine switches off
and the blade (16) is braked.
2. The blade (16) must stop within 7 seconds.
10.5
Switching the product on/off (Fig.
18)
Note:
The charge status of the battery is indicated by the corre-
sponding LED light lighting up.
Low
High
Switching on
1. Hold the on/off button (11) depressed and pull the
safety bar (1) rearwards.
Low battery charge status
High battery charge status
www.scheppach.com
Switching off
1. Release the safety bar (1).
2. Pull out the safety key (14).
3. Remove the battery.
CAUTION
After switching off, the product will run on. Wait until the
product has come to a complete stop.
10.6
Auto/Eco mode (Fig. 1)
The product automatically starts up in the last mode used.
1. You can switch between Auto/Eco mode by pressing
the Auto/Eco switch (12).
Auto mode:
The product adjusts the motor speed to suit the load.
Eco mode:
The product runs at the lowest speed for maximum run-
time.
10.7
After mowing
• Check all screws and nuts before the next use. Tight-
en up loose screws.
• Empty the grass collection basket before the next use.
• Please also observe the chapter "Storage".
11 Cleaning and maintenance
WARNING
Have maintenance and repair tasks that are
not described in this operating manual, car-
ried out by a specialist workshop. Use only
original spare parts.
There is a risk of accident! Always perform
maintenance and cleaning work with the bat-
tery removed. There is a danger of injury! Let
the Product cool down before all mainte-
nance and cleaning tasks. Elements of the
engine are hot. There is a danger of injury
and burning!
The product can start unexpectedly and cause injuries.
–
Remove the battery.
–
Allow the product to cool down.
–
Remove the tool attachment.
11.1
Cleaning
• Keep protective devices, air vents and the motor
housing as free of dust and dirt as possible. Rub the
product clean with a clean cloth or blow it off with
compressed air at low pressure. We recommend that
you clean the product directly after every use.
• Ventilation openings must always be free.
• Cleaning with a garden hose is only recommended at
low pressure. A high-pressure cleaner is not suitable
for cleaning the lawnmower.
GB | 29
Publicidad
