Publicidad
Idiomas disponibles
Idiomas disponibles
PROBLEM
Pressure washer does not start when
trigger is depressed
Pump doesn't produce pressure
Machine doesn't reach high pressure
No detergent
Detergent fails to mix with spray
Wand leaks
TROUBLESHOOTING
POSSIBLE CAUSE
Battery pack not installed
Battery is low in charge
The on/off switch is in the off posi-
tion (O)
Inadequate water supply
Trigger handle leaks
Nozzle is clogged
Pump is faulty
Air in line
Water inlet filter is clogged or dirty
Diameter of garden hose is too small
Water supply is restricted
Not enough inlet water
Hose is leaking
Kink in hose
Water supply is inadequate or clogged
Wrong nozzle is attached
High pressure nozzle attached
Soap injection hose not properly sub-
merged
O-ring needs replacing
15 — English
SOLUTION
Install a battery.
Charge the battery.
Put the on/off switch in the position
(I) ECO.
Provide adequate water flow.
Check connections and / or replace
trigger handle.
Clean nozzle.
Contact authorized service center.
Squeeze trigger on trigger handle to
remove air from line.
Remove the water inlet filter, rinse
with warm water, then replace in unit.
Replace with 3/4 in. garden hose.
Check garden hose for kinks, leaks,
and blockages.
Open water source full force.
Replace hose.
Eliminate kinks in hose.
Check garden hose for kinks, leaks
and blockages.
Attach blue or black soap nozzle.
Use blue or black soap nozzle to ap-
ply detergent
Insert soap injection hose into soap
container
Replace o-ring. If this does not correct
the problem, contact your authorized
service center to purchase a new
wand.
Publicidad
