Publicidad
Idiomas disponibles
Idiomas disponibles
▪ Installation
Let your device breathe. Heat is released from the walls so it is important to leave a circulation
of air around your device.
Energy saving tips
▪ The appliance should be located in the coolest area of the room, away from heat
producing appliances or heating ducts, and out of the direct sunlight.
▪ Let hot foods cool to room temperature before placing them inside. An overload will
force the compressor to run longer. Food that freezes too slowly may lose quality, or
deteriorate.
▪ Be sure to wrap foods properly, and wipe containers dry before placing them in the
appliance. This cuts down on frost build-up inside.
▪ Storage bin should not be lined with aluminum foil, wax paper, or paper toweling. Liners
interfere with cold air circulation, making the appliance less efficient.
▪ Organize and label food to reduce door openings and extended searches. Remove as
many items as needed at one time, and close the door as soon as possible.
Reversing the door
Tool required: Philips screwdriver, Flat bladed screwdriver, Hexagonal spanner.
• Ensure the device is empty and unplugged.
• To take the door off, it is necessary to tilt the device backwards. You should rest the
unit on something solid so that it will not slip during the door reversing process.
• All removed parts must be saved to do the reinstallation of the door.
• Do not lay the device flat as this may damage the coolant system.
• It's better that 2 people handle the device during assembly.
1. Remove four screws in top cover and then lift it.
2. Unscrew top hinge and then remove upper door and place it on a soft pad to avoid scratch.
3. Remove the pin with a screwdriver and flip the hinge bracket. Then refit the pin to hinge
bracket.
4. Unscrew middle hinge. Then lift lower door and place it on a soft pad to avoid scratch.
5. Move the hinge hole covers from left side to right side.
6. Unscrew bottom hinge. Then remove the adjustable feet from both sides.
7. Unscrew and remove the bottom hinge pin, turn the bracket over and replace it.
8. Refit the bracket fitting the bottom hinge pin. Replace both adjustable feet. Transfer the
lower door to the property position.
9. Make the middle hinge reverse the direction180°, then transfer it to the left property
position. Make the middle hinge pin in the upper hole of the lower door, then tight the bolts.
34
Publicidad
