Publicidad
Idiomas disponibles
Idiomas disponibles
Initial Operation
• Protect the tool against moisture and
direct sun irradiation.
• D o n o t s u b j e c t t h e t o o l t o e x t r e m e
t e m p e r a t u r e s
temperature. As an example, do not leave
it in vehicles for longer periods. In case of
large variations in temperature, allow
the tool to adjust to the ambient
temperature before putting it into operation.
In case of extreme temperatures or
variations in temperature, the accuracy of
the tool can be impaired.
• Avoid heavy impact or falling of the tool.
After heavy exterior impact on the tool, an
accuracy check should always be carried
out before continuing to work (see "Leveling
Accuracy").
• Switch the tool off during transport.
When switching off, the leveling unit, which
can be damaged in case of intense
movement, is locked.
Switching On and Off
To switch on the tool, slide the On/Off switch
3 to the "On" position. Immediately after
switching on, the tool sends laser beams out
of the exit openings 1.
• Do not point the laser beam at persons
or animals and do not look into the laser
beam yourself, not even from a large
distance.
To switch off the tool, slide the On/Off switch
3 to the "off" position. When switching off, the
leveling unit is locked.
• Do not leave the switched on measuring
tool unattended and switch the tool off
after use. Other persons could be blinded
by the laser beam.
The tool switches off automaically after an
operating duration of 30 minutes.
Operating Modes
The tool has total of six operation modes that
can be switched through in sequence
In any of the first three operation modes
(Automatic Self-Leveling), if the tool is tilted
more than 4° in any direction, the laser
lines will blink slowly (Out-Of-Level error) to
indicate the tool is currently not self-leveling.
Bring the tool to a more level position before
o r
v a r i a t i o n s
Operation
continuing work.
– Horizontal operation "–": Produces a
horizontal laser line,
– Vertical operation "l": Produces a vertical
laser line,
i n
– Cross-line operation "+": Produces a
horizontal and vertical laser line.
The tool has three Slope modes that can be
switched through in sequence. The operating
mode button 4 will illuminate while Slope
modes are selected. The tool will not indicate
Out-Of-Level (OOL) in Slope mode.
– Horizontal operation "-" produces a
horizontal laser line.
– Vertical operation "I" produces a vertical
laser line.
– Cross-Line operation "+" produces vertical
and horizontal laser lines.
After switching on, the tool is in cross-line
operating mode. To change the operating
mode, press the operating mode button 4.
Automatic Leveling
Working with Automatic Leveling
Position the tool on a level and firm support,
attach it to the magnetic bracket 9 or to a
tripod.
After switching on, the leveling function
automatically compensates irregularities
within the self-leveling range of ±4°. The
leveling is finished as soon as the laser
beams do not move anymore.
If the automatic leveling function is not
possible, e.g. because the surface on which
the measuring tool stands deviates by more
than 4° from the horizontal plane, the laser
beams flash slowly. In this case, bring the
tool to the level position and wait for the self-
leveling to take place. As soon as the tool is
within the self-leveling range of ±4°, the laser
lines light up continuously again.
In case of ground vibrations or position
changes during operation, the tool is
automatically leveled in again. To avoid
errors, check the position of the horizontal and
vertical laser line with regard to the reference
points upon re-leveling.
-7-
Publicidad
