MESTIC SMART ADVENTURE MI-500 Instrucciones De Uso página 36

2. RJ11 pin definition
Pin
1
2
3
3. Connecting a remote switch
Turning on the inverter
1. Connect the breaker to the inverter input terminal or the fast-acting fuse to the battery terminal.
2. Turn on the inverter switch, and the green indicator will light up, indicating normal AC output.
3. Connect the breaker at the AC load terminal, turn on the AC loads, and check the system's
working status.
4. Note: When supplying power to different loads, it is recommended to first turn on the load with
a large impulse current, and then turn on the load with a smaller impulse current after the load
output is stable.
5. If the FAULT indicator flashes red, and the buzzer alarms after powering the inverter,
immediately turn off the load and the inverter. Clear the faults according to the chapter
"Troubleshooting." After clearing the faults, operate the inverter again by following the steps
above.
Setting Parameters
Parameters such as power-saving mode, baud rate, output voltage class, and output frequency class
can be configured using the optional remote inverter display (additional purchase required), phone
app, or PC software. The following chapters use parameter setting on the remote inverter display as
an example.
Definition Instruction
Switch+ Switch+
Switch- Switch-
+5VDC 5V/200mA
Pin Definition
4 LED_R
5 GND
6 LED_G
Instruction
Red light
drive
Power GND
Green light
drive