Dometic BUTTNER TEMPRA TLB100 Instrucciones De Montaje Y De Uso página 6

EN
NOTICE! Damage hazard
To prevent damage to the equipment, deactivate all loads and the charger before battery installation.
NOTICE! Damage hazard
Battery cables must not be connected to the battery in reverse polarity, otherwise damage to the device
may occur.
NOTICE! Damage hazard
To prevent damage to the equipment always connect the positive cable first.
NOTICE! Damage hazard
Never connect multiple batteries in series.
NOTE The battery may only be installed in upright position on a horizontal surface.

1. Remove the terminal protection caps (1).
2.
NOTE Automotive terminal clamps may be connected with M8 screws and suitable washers.
Install the battery cables (2) to the corresponding terminal (3) using the bolts (4) included in the scope of deliv-
ery.
To ensure a secure electrical contact tighten the bolts to the end of the threads, but without using excessive
force.
3. Install the terminal protection caps (1).
4. If possible, secure the battery to the floor to avoid unexpected movements during the journey.
Installing and connecting the display (optional)
1. Follow the instructions given in the display manual.
6