camry Premium CR 5039 Manual De Uso página 4

13. Do not let cord hang over edge of counter or touch hot surfaces.
14. In order to provide additional protection, it is recommended to install residue current
device (RCD) in the power circuit, with residual current rating not more than 30 mA. Contact
professional electrician in this matter.
15. If it is necessary to use an extension cord, use only one with a grounding pin and rated
for the power load of at least the iron connected to it. The other ("weak") extension cords
can overheat. The cable should be arranged to avoid accidental strokes or stumbles over it.
16. Always, before filling with water or when the steam iron is not used, unplug it from the
mains.
17. Touching a hot soleplate, contact with hot steam or water may cause burns. Be careful
when you rotate the iron, as in the tank, even when disconnected from the power supply
iron, may still be in hot water.
18. DO NOT allow for prolonged contact hot steam iron with fabric or flammable materials.
19. Be careful that the power cord does not touch the hot soleplate. Allow the iron to cool
completely before storage.
20. If you do not use iron, even for a short time, turn off the options of steam
21. Under no circumstances should be ironed clothes and fabrics that are on humans or
animals.
22. Never direct the steam to humans or pets.
23. Iron must be used at a stable even surface and this can only be disposed of.
24. Do not fill the water tank with chemicals, perfumes or descaling substance.
25. Do not fill the water tank over MAX level.
DESCRIPTION OF DEVICE
A. Soleplate
B. The water inlet hole
C. Steam Control button
D. Power Cord
E. Water tank
F. Thermostat indicator light
G Thermostat knob - temperature control
H. Voltage switch 220-240V / 100V-127V
ATTENTION!!
After unpacking the device, check the mains voltage and set the voltage switch (H) to the appropriate position.
It is forbidden to change the position of the voltage switch (H) while the device is operating
For the safety of users, each iron is filled with water and tested during the quality control process. Therefore, it may happen that a few
drops of water escape from the device before first use, which is normal.
IRONING
First use
When using the iron for the first time, you may notice a slight emission of smoke and hear some sounds made by the expanding plastics.
This is quite normal and it stops after a short time. We also recommend passing the iron over an ordinary cloth when using it for the first
time.
Preparation
Sort the laundry to be ironed according to the international symbols on the garment label, or if this is missing, according to the type of
fabric.
4