Schneider Airsystems A 888 007 Manual De Instrucciones Original página 13

1.5 Components
01 Compressor unit
02 Intake filter
03 Oil filler plug
04 Mini ball valve (oil drain)
05 Oil inspection glass
06 Pressure pipe
07 Check valve
08 Vessel
09 Dirt arrester
10 Pressure switch with ON/OFF switch
11 Safety valve
12 Pressure gauge (vessel pressure)
13 Pressure gauge (working pressure)
14 Electric motor
15 V-belt pulley
16 V-belt
17 Fan wheel
18 Pressure reducer
19 Quick-action coupling (clean, regu-
lated compressed air)
20 Mist oiler
21 Quick-action coupling (oil-mist com-
pressed air)
22 Connecting hose
23 Console (compressor unit)
24 Console (electric motor)
25 Vibration damper
26 3/2-way value for automatic conden-
sate drainage
27 Control line (3/2-way valve)
28 Condensate collection pipe
29 Condensate evaporator
30 Operating panel
31 Regulating screw (mist oiler)
32 Water separator with filter
33 Float valve
34 Operating hours counter
35 Service outlet
36 Alternating current plug (service out-
let)
37 Three-phase
motor)
current plug (electric
MAS 500-10-60 D-Silent
38 Guide roller with locking brake
39 Maintenance flap
40 Hose rewinder (optional)
41 Fan wheel
42 Air inlet
L For equipment that does not have a safety
valve on the tank, the safety valve is lo-
cated by the
Chapter for more information1.6.2.
1.6 Maintenance
1.6.1 Cleaning the intake filter
1. Unscrew the intake filter. (Fig. 5a)
2. Clean the filter insert using the blow gun,
exchange the filter insert if necessary.
3. Screw the intake filter back on.
1.6.2 Replacing the safety valve
For compressors that have a safety valve by
the pressure switch:
1. Unscrew the cover plate (Figure 17a).
2. Pull cover plate down and forward.
3. Remove cover plate.
1.7 Compressor inspections
This compressor is subject to a type approval
inspection. As a result, inspections by an au-
thorised expert prior to commissioning are
no longer necessary. The prototype identi-
fication code is located on the compressor
specification plate.
We recommend that a "qualified person"
perform a pressure test on the vessel after
10 years, depending on general levels of
wear and tear.
A "qualified person" should be well informed
about Ordinance on Industrial Safety and
Health (formerly authorised expert)
Contact any of our approved service part-
ners. Most of our service partners have em-
ployees with expert qualifications.
L The papers accompanying the vessel are
approval documents and must be kept
throughout the service life of the vessel.
These specifications only apply in Germa-
ny. Equivalent regulations apply in other
countries.
pressure switch.
GB
See
I/5