Tunturi PLATINUM FG60 Manual De Montaje página 15

Accessories (fig� D-7)
‼
NOTE
• The shown illustration shows how the trainer
will look with the suitable Platinum FG60
Utility Bench Connector Set
• The additional Platinum FG60 Utility Bench
Connector Set can be purchased as an
accessory.
• Article nr: 22PTFG6020
Contact your dealer for further information.
Free area (Fig� D-0)
Adequate space is a prerequisite for use�
The free area should be no less than 0.6m greater
than the *training area in the directions from
which the equipment is accessed.
The free area must also include the area for
emergency dismount. Where equipment is
positioned adjacent to each other, the value of
the free area may be shared.
*Training area is the maximum length/width/
height of the trainer, including moving parts, been
measured to its maximum length/ width/ height
during use.
IMPORTANT
Because your trainer will/ can set in the first
using hours, we recommend you do a quick
check on the hardware you have fitted during
your assembly.
We suggest tightening all bolts and nuts once
again after the first few workout sessions
(approximate 10 hours).
Just to assure the bolts and nuts are
still tightened well for your trainer's best
performance.
‼
NOTE
• We recommend checking the hardware
regularly, at least once every 3 months.
Additional environmental information
Packaging disposal
Government guidelines ask that we reduce the
amount of waste material disposed of in land fill
sites. We therefore ask that you dispose of all
packaging waste responsibly at public recycling
centres.
End of life disposal
We at Tunturi hope you enjoy many years of
enjoyable use from your fitness trainer. However,
a Time will come when your fitness trainer will
come to the end of its useful life. Under 'European
WEEE Legislation you are responsible for the
appropriate disposal of your fitness trainer to a
recognised public collection facility.
Use
Using weight plates
- When using weight plates, do make sure to
use sufficient locking supports to secure your
weight plates at all times before use.
- Never exceed the maximum weight capacity of
the barbell bar and or bench.
To take not of your own body weight too.
Adjusting the backrest inclination
- Tilt the backrest slightly and tilt the adjusting
bar out of the toothed plates.
- Move the backrest into the required position.
- Position the adjusting bar in the toothed plates
to secure it.
See adjustment option range Fig E
Adjusting the vertical seat position
- Tilt the seat slightly and tilt the adjusting bar
out of the toothed plates.
- Move the seat into the required position.
- Position the adjusting bar in the toothed plates
to secure it.
See adjustment option range Fig E
English
15