OPERATING AND MAINTENANCE MANUAL
BEDFORD W191 ELECTRONIC VARIABLE SPEED DRIVE
Method 2: Directly setting at the primary interface
Method 2: Directly setting at the primary interface
Press
or
at primary interface when the controller is in stop or run status, the system will
Press
switch automatically to display setting pressure, press
the system will switch automatically to display setting pressure, press
increase/decrease. In the adjustment process, the controller will automatically track to operate and
or
again, the setting pressure increase/decrease. In the adjustment process,
automatically saves the pressure value.
the controller will automatically track to operate and automatically saves the pressure
value.
5. INSTRUCTIONS OF PARAMETERS GROUP
5. Instructions of Parameters Group
Function
Name
Code
br-00 Group
Debugging
b00.00
Password
Run Mode
b00.01
Selection
Setting
b00.02
Pressure
Motor
b00.03
Rotating
Direction
Water Tower
b00.04
Replenishment
Interval Time
Manual
b00.05
Frequency
Setting
www.proindecsa.com / proindecsa@proindecsa.com
W191 Series Intelligent Controller for Water Pump User Manual
or
at primary interface when the controller is in stop or run status,
Setting
Factory
Range
Default
0~65535
65535
0~4
b00.09~
3.0bar
b00.08-1.0
0~1
0.1~12.0
b00.26~
50.00Hz
b00.25
or
Settingdetermined by b00.45, When b00.45 is
set to 0, theb00.00password is invalid. When
b00.45 is set to a non-zero value, the b00.00
password is valid.
0: Upper boost mode (Const.P. indicator light
on)
1: Lower boost mode (Const.P. indicator light
flashes)
0
2: Water Tower replenishment mode ("Water
Tower" indicator light on)
3: Manual mode ("Manual" indicator light on)
4: Fan mode ("Manual" indicator light flashes)
Pressure setting according to the actual
requirement of user (invalid in manual / fan
mode)
0: Forward
0
1: Reverse
Every once in this while, start the water pump
6.0h
to replenish water to the water tower
Water pump running frequency (valid in
manual / fan mode)
29
Page 9
again, the setting pressure
Description