monzana DBHK002 Manual De Instrucciones página 15

• Select a suitable location. Observe the safety information listed above.
• Plug the heater mains plug into a suitable socket.
• Turn the thermostat knob clockwise to the maximum setting position.
• Switch on the heating elements using the rocker switched attached to the side panel. The switch
will illuminate once the heating elements are switched on. Both switches must be switched on
for maximum heating output.
• Once the desired room temperature is reached, the thermostat knob must be slowly turned
counter-clockwise until a "click" noise indicates the thermostat has been switched off. The
switch illumination turns off. The thermostat will now maintain the room temperature by turning
on and off automatically.
Model DBHK002 - Convector heater with thermostat and timer
Control panel
All instructions that are described for the model DBHK011 also apply to the model DBKH002. This
model is also equipped with a 24-hour timer.
This timer has a total of 48 segments for the entire day, which corresponds to 30 minutes per
segment. The timer can be used to set the time and duration within a 24-hour cycle during which
the heater is to be switched on.
Timer operation
In the middle area, the timer has a slide switch with 3 positions. In the middle position (marked by
a clock symbol), the timer will switch the heating elements on or off according to the preset timer
segments (how to set the timer is described below). The position marked with an "I" bypasses the
timer. The timer will continue to run, but the heater is continuously powered. This means that the
heating elements are run for the entire time, if desired. In the "O" position, the timer continues to
run, but the heater is not powered.
Setting the timer
Make sure that the timer's slide switch is in the middle position with the clock symbol. Turn the
outer ring clockwise until the arrow matches the current time. If, for example, the timer is to be set
to 20:00, the outer ring should be turned until the number 20 matches the arrow. Set the heater's
operating time by pulling the corresponding segments on the outer ring. After setting the heater,
the heater will operate every day at the set time with the programmed setting.
Note: The heater's mains plug must be connected to the grid the entire time and the rocker
switches must be switched on. Moreover, the thermostat must be set accordingly to ensure that
the device switches on.
1. Rocker switch heating level 1
2. Rocker switch heating level 2
3. Thermostat
4. Slide switch
5. Arrow (time)
6. Segments
15 www.DEUBAXXL.de