Publicidad
Idiomas disponibles
Idiomas disponibles
If you want the heater to work the entire time, the slide switch must be in the "I" position. If it is
necessary to change to the timer mode later, the slide switch must be pushed into the middle
position with the clock symbol.
Note: It must be noted that the heater can switch on in unobserved situations while in timer mode.
Overheating protection
1.
An additional built-in safety thermostat protects the heater from overheating and switches it
off automatically. The service lamp then goes off. After a short cool-down phase (about 15
minute), the heater is ready for use again.
2.
If this should repeat, first check whether the thermostat switch is correctly set or whether
objects are preventing heating operation.
7.0 MAINTENANCE AND CARE INSTRUCTIONS
Always switch off the appliance and disconnect the mains plug before carrying out maintenance
or inspection work.
Check all the parts for signs of wear. Do not continue to use the product if you find any defects.
Only have parts replaced with original spare parts by a specialist in accordance with the
manufacturer's specifications. A lack of care and maintenance can damage the appliance.
Dangerous situations can arise. To ensure electrical safety, the appliance must not be treated with
or even immersed in liquids. Regular maintenance helps to ensure the safety of the product and
increases its service life.
Warning: Allow the heater to cool down completely before cleaning or storage!
Cleaning
It is bets to clean the ventilation grilles at the bottom and bottom using a soft brush. If necessary,
wipe the housing with a soft dry cloth. If heavily soiled, please use a slightly dampened cloth. Do
not use cleaners or detergents containing solvents; substances such as bleach can damage the
product.
Storage
If the heater is not used for a longer period of time, it should be stored protected from dust and
in a clean dry location.
8.0 TROUBLESHOOTING
Problem
The device is not
working
Fuse
trips
when
switching
on
or
after
a
short
operation duration
The device switches
off automatically
Possible cause
No power supply
Device defective
The load on the circuit is too
high.
The overheating protection
has tripped
Solution
Check the fuse, power cable and mains
plug
Contact Customer Service
Do not operate any larger consumers
(kettle, coffee machines, etc.) on the
same circuit simultaneously
After a short cool-down phase (about 15
minute), the heater is ready for use
again.
16
www.DEUBAXXL.de
Publicidad
