Fein Slugger 7 273 Serie Instrucciones De Uso página 24

en
24
Starting and stopping the drill motor
(figure 15).
Starting:
Switch the motor switch ON.
Stopping:
Switch the motor switch OFF.
Shutting magnet OFF:
Switch off the magnet with the magnet
power switch.
When the power supply is disconnected
while the motor is running, a protective cir-
cuit prevents automatic restarting of the
motor. Restart the motor again.
In case of improper use, the motor can
become damaged.
When the motor has cooled down, the mag-
netic core drill unit can be switched on
again.
To reduce the cool-down period, the motor
can be switched on by pressing and holding
the ON button. During the cool-down period,
the motor will only run while the ON button
is pressed.
Do not stop the drill motor during the drill-
ing procedure.
The magnetic core drill unit is equipped with
a overload protection. When the motor gets
too warm, the magnetic core drill unit
switches off.
Fig. 15
Switching the
drive motor on
Switching the
drive motor off