Packing And Unpacking; Unpacking, Moving, Use And Storage; Setting To Work - Connection To The Power Supply - Nilfisk cfm VHW320 Manual De Instrucciones

Packing and unpacking

Dispose of the packing materials in compliance with the laws
in force.
Figure 2
VHW320 MODEL
(mm)
Standard
(500)
IC
(500)
VHW321 MODEL
(mm)
Standard
(500)
VHW420 MODEL
(mm)
Standard
(620)
IC
(620)
C
(620)
VHW421 MODEL
(mm)
Standard
(620)
VHW440 MODEL
(mm)
Standard
(620)
IC
(620)
C
(620)
10/2013
A B C
Ibs.
in. in. in.
(kg)
(mm) (mm)
19.7 35.4 53.5 190
(900) (1360) (86)
19.7 35.4 64.2 236
(900) (1630) (107)
A B C
Ibs.
in. in. in.
(kg)
(mm) (mm)
19.7 35.4 53.5 201
(900) (1360) (91)
A B C
Ibs.
in. in. in.
(kg)
(mm) (mm)
24.4 41.3 65.4 267
(1050) (1660) (121)
24.4 41.3 76.8 337
(1050) (1950) (153)
24.4 41.3 76.8 357
(1050) (1950) (162)
A B C
Ibs.
in. in. in.
(kg)
(mm) (mm)
24.4 41.3 65.4 300
(1050) (1660) (136)
A B C
Ibs.
in. in. in.
(kg)
(mm) (mm)
24.4 41.3 65.4 295
(1050) (1660) (134)
24.4 41.3 76.8 365
(1050) (1950) (165)
24.4 41.3 76.8 386
(1050) (1950) (175)
VHW320 - VHW321 - VHW420 - VHW421 - VHW440

Unpacking, moving, use and storage

Operate on flat, horizontal surfaces.
The load-bearing capacity of the surface the vacuum cleaner
is placed on must be suitable for bearing its weight.
Setting to work - connection to the power
supply
WARNING!
■ Make sure there is no evident sign of damage to
the vacuum cleaner before starting work.
■ Before plugging the vacuum cleaner into the
electrical mains, make sure the voltage rating
indicated on the data plate corresponds to that of
the electrical mains.
■ Plug the vacuum cleaner into a socket with a
correctly installed ground contact/connection.
Make sure that the vacuum cleaner is turned off.
■ The plugs and connectors of the power supply
cords must be protected against splashes of water.
■ Check for proper connection to the electrical
mains.
■ Use the vacuum cleaner only when the cord
that connects to the electricity mains is in good
condition (damaged cords could lead to electric
shock!).
■ Regularly check there are no signs of damage,
excessive wear, cracks or aging on the electric
cord.
WARNING!
When the device is operating, do not:
■ Crush, pull, damage or tread on the cord that
connects to the electrical mains.
■ Only disconnect the cord from the electrical mains
by removing the plug (do not pull the cord).
■ Only replace the electric power supply cord with
one of the same type as the original:
1-phase and SOOW for 3-phase.
applies if an extension is used.
■ The cord must be replaced by the manufacturer's
Service Center staff or by equivalent qualified
personnel.
5
SJOOW for
The same rule
US
C394