Publicidad
Idiomas disponibles
Idiomas disponibles
INTRODUCTION
EN
Thank you for the purchase of our quality product. Used carefully and in accordance with the instructions set
out below. Please read and keep these instructions for future reference.
MOUNTING INSTRUCTIONS
1. Open the box and take out the fan.
2. Mark the center of the installation support.
Pass the main conductors through the holes in
the installation bracket; Make sure the bracket is
on the roof beam using flat washers, pressure or
lock washers, screws and wall washers.
3. Install the fan blades on the motor by adjusting
all the screws and the pressure or safety
washers.
4. Lift the fan and slide the nylon ball until it
covers the base. Make sure that the hook on the
base fits correctly into the groove of the dial.
5. Connect the cables as follows: Black wire
<L>, white wire <N>, and green and yellow wire
<GROUND TIE>.
20 | www.garsaco.com
6. Install the top bracket on the installation plate;
Hang the fan on two of the screws and pass the
washers through the keyholes. Make sure that no
part of the cable is crushed during installation. Screw
in all the screws and check that the upper support is
correctly positioned and that the cable has not been
crushed. Make sure that the guide in the form of a
coupling pin fits perfectly into the groove.
WALL CONTROLLER INSTALLATION
1. Pass the wires through the hole on the switch box
and mount it to the wall by tightening the screws and
washers (Fig.1).
2. Made wire connection correctly (Fig 2).
3. Attached the switch cover onto the switch box by
tightening the screws in bag, and put the cap into
screw holes (Fig. 2).
FUNCTIONS WALL CONTROLLER
2
3
1
0
The wall controller serves
to control the fan speed. To
select the desired speed
the wheel must be rotated
in the interval from 1 to 3.
The 1 being the slowest
speed and the 3 the fastest
speed.
Publicidad
