Publicidad
Idiomas disponibles
Idiomas disponibles
4. TO REMOVE OR INSTALL BATTERY PACK
(See Fig. I)
Depress the battery pack release button to remove
the 2 battery packs from your tool. After recharging,
insert the 2 battery packs into the battery ports. A
simple push and slight pressure will be sufficient until
a click is heard. Check to see if the battery is fully
secured.
NOTE:
• When removing the battery pack, hold it firmly
to avoid dropping and injury.
• This machine will only run when 2 batteries are
installed. It is recommended to use the same
two batteries and charge the two batteries at
the same time.
• When you use two batteries with different
power, the machine will only run to the lower
common denominator.
I
5. POWER INDICATOR LIGHT (See Fig. J)
IMPORTANT:
When only one light is illuminated, your battery is
overly discharged, even though the machine may
still be capable to work. Continuing to operate
your machine with the battery in this discharged
condition may reduce the life and performance of
your battery.
When no light are illuminated, at least one battery
is not fully installed or battery may be defective,
please double check the batteries are fully seated
into position.
J
BATTERY STATUS
• Before starting or after use, press the button
beside the power indicator light on the machine to
check the battery capacity.
• During operation, the battery capacity will be
indicated automatically by the battery power
indicator. The indicator constantly senses and
displays the battery condition as follows.
• For the machine with 2 battery packs with different
power, the power indicator light displays the
battery condition with the lower one of the two
batteries.
Battery indicator
light status
Five green lights
The two batteries are in a
(
) are
highly charged condition.
illuminated.
Two, three or four
The two batteries have a
green lights are
remaining charge. The more
illuminated.
lights are illuminated, the
more battery capacity.
Only one green
The battery level of at least
light (
)
one battery pack is very low.
is illuminated.
Please check and charge the
battery pack.
No light is
At least one battery is not fully
illuminated.
installed or battery may be
defective.
Only one light is
At least one battery is over
flashing twice per
discharged (please refer to
cycle.
the battery charge condition),
please recharge the two
batteries at once before use
again or storage.
Only one light
At least one battery is hot,
is flashing three
wait for them cool down
times per cycle.
before start again.
Only one light is
The machine is over load.
flashing four times
Remove tool from cutting
per cycle.
area and try again.
6. SWITCHING ON AND OFF (SEE FIG. K)
ATTENTION: Check the battery packs before using
your cordless tool.
For switching on the tool, press the lock-out button,
then fully press the on/off switch and hold in this
position. The lock-out button can now be released.
For switching off, release the on/off switch.
NOTE: The chain brake must be activated in order for
the saw to be switched on.
Battery condition
EN
15
Publicidad
