EDM Product 08473 Manual De Instrucciones página 21

STEP 6
Attach the hose connector to the pressure washer. Before attaching the
connector to the male fitting, remove the plastic cap that is inserted
into the male fitting of the pressure washer prior to shipment. Once
removed, this plastic cap can be discarded. After both components have
been installed, connect the garden hose to the garden hose with the
screwed connector on the pressure washer. Connect the garden hose
to the water tap.
STEP 7
If the water source is located below the machine inlet, the water drop to
the machine inlet should not exceed 50 cm.
If the water source is located above the machine inlet, the water surface
must not exceed 50 cm to the top of the water container. In this case,
the nozzle cannot be installed. After starting the machine, wait for the
water to flow from the gun head and then connect the nozzle for use.
Instruction manual
STEP 8
The machine is equipped with a liquid regulating valve that allows you
to adjust the foam to your liking during operation. When the foam is too
dense, you can turn the knob to adjust it or turn it off completely to the
"MIN" (minimum) position, and vice versa, for more foam, you can turn
it to the "MAX" (maximum) position.
STEP 9
When it is necessary to adjust the height of the lever during use, you can
adjust the lever to the appropriate height while holding it in the position
shown in the figure.
INSTRUCTIONS
START-UP
After connecting the pressure washer to the cold water supply, proceed
as follows:
▶Make sure that the ON/OFF switch is in the OFF position.
▶Connect the garden hose to the inlet connector.
▶Insert the adjustable spray nozzle into the gun according to assembly
▶Connect the high pressure hose to the high pressure outlet connector
21
step #3.
according to assembly step #4.
ref. 08473
ES
PT
EN
FR