Descargar Imprimir esta página

Snapper RZT26520 Manual Del Operador página 23

Publicidad

Idiomas disponibles

Idiomas disponibles

B
Figure 13. Seat Adjustment
Seat Adjustments
The seat and ground speed levers should be adjusted
so that operator's elbows are supported by the arm rests
when his/her hands are on the controls, and the ground
speed levers can be moved through their full range of
motion without contacting the operator's legs.
Seat Position Adjustment
Lift the seat adjustment lever (A, Figure 13). Slide the
seat forward or backward to the desired position, then
lower the seat adjustment lever. Make sure the lever
locks into the locking slots (B) in the seat base.
Ground Speed Lever Adjustment
Remove the ground speed lever mounting hardware
(Figure 14) and reposition the lever either up or down
from its original position. Replace the hardware.
A
Adjustments and Service
Figure 14. Ground Speed Lever Adjustments
Speed Balancing Adjustment
If the rider drifts to the right or left when the ground
speed levers are in the maximum forward position, the
top speed of each of these levers can be balanced. Only
adjust the speed of the wheel that is traveling faster.
To Reduce the Speed of the Faster Wheel
1. Loosen the bolt securing the forward adjust plate
(Figure 14).
2. Slide the plate up approximately 1/8".
3. Retighten the bolt and recheck speed balance.
4. Repeat steps 1-3 until adjustment is complete.
WARNING
DO NOT adjust the rider for a faster overall speed
forward or reverse than it was designed.
23

Publicidad

loading

Este manual también es adecuado para:

285z serie7800632