EN
CAUTION! Always unplug the steamer from the power supply before attaching or removing the
brush attachment. Warning! The steam soleplate may still be hot.
The brushes improve the penetration of steam into thick and heavy fabrics, allowing fast-
er results. Brush attachments are intended for use with steam.
USING THE FOOD PROCESSOR
1. Connect the power cord plug (7) to a grounded power socket. The indicator light (4) will start
flashing.
2. The steamer heats up and is ready for use after about 30 seconds. This is signalled by the constant
lighting of the control lamp (4).
3. When the device is ready to use, press the steam activation button (5). Before starting ironing,
direct the steam stream away from the clothing for a few seconds, as the initial steam stream may
contain drops of water.
4. Press the on/off button to stop steaming.
5. If the brush attachment is not in use during steam ironing, keep the steam foot 5 cm away from
the fabric.
6. During steam ironing, bring the steam soleplate closer to the garment. At the same time, use your
other hand to pull the sides of the garment to straighten it.
CAUTION! Do not aim the steam directly at metal accessories. Be careful around metal acces-
sories.
7. After steam ironing, press the on/off switch.
To make it easier to iron items of clothing, hang them on a hanger.
For shirts with buttons, fasten the first button at the collar to make it easier to straighten
the fabric.
CAUTION! Do not support the fabric with your unprotected hand during steam ironing. Do not
place the steam foot on the power cord after use.
Steam ironing may cause small wet spots on the garment. Clothing may also be slightly
damp due to steam.
At the end of your session, let your garment dry before putting it on or putting it back on.
ATTENTION! The steamer is designed to be used vertically and horizontally. The device should
not be turned upside down.
CAUTION! The work of the water pump can be heard as a soft hum initiating by pressing the
steam button. If there is no water in the tank, the operation of the pump will be louder. If such
situation occurs, the water tank should be refilled.
The device is equipped with an automatic shut-off function. This function is launched
when the device is not used for a long time. This function is signalled by the blinking of
the control lamp (4).
CAUTION! The device produces steam at a very high temperature! Risk of scalding! Do not direct
the vapor stream at people or animals!
AFTER FINISHING IRONING
1. Turn off the device using the switch (5).
2. Unplug the power cord (7) from the electrical socket.
3. Empty the water tank (6).
4. Put the device in a safe place in an upright position and wait for it to cool down.
22