To Start The Product; To Stop The Product : Ebz8550Rh - RedMax EBZ8550 Manual Del Usuario

To operate the throttle switch :
EBZ8550RH
• Apply full throttle (1).
• Apply 1/3 speed (2).
• Apply idle speed (3).
• Stop the product with the stop switch (4).
3
4
To operate the throttle switch :
EBZ8550
• Apply full throttle (1).
• Apply 1/3 speed (2).
• Apply Idle speed (3).
• Stop the product with the stop switch (4).
4

To start the product

1. If the engine is cold, push the choke lever to the
closed choke position.
12
2
1
1
2
2. Push the air purge bulb again and again until fuel
starts to fill the air purge bulb. It is not necessary to
fill the air purge bulb fully.
3. Push the throttle lever to the 1/3 speed position.
To operate the throttle switch : EBZ8550RH
Refer to
on page 12 .
4. Put the product on a flat surface on the ground.
5. Hold the product with the left hand.
6. Put your right foot on the frame.
7. Pull the starter rope handle slowly until resistance
occurs.
8. Pull the starter rope handle quickly with the right
hand until the engine starts or attempts to start,
maximum 10 times. If the engine starts, move the
choke lever gradually to the open position.
Note: Do not pull the starter rope handle to full
extension and do not let go of the starter rope
handle.
9. Move the choke lever to the open choke position
until the choke lever stops.
10. Pull the starter rope handle repeatedly until the
3
engine starts and continues to run.
11. If the engine does not start, do step 1 to step 10
again.
12. Let the engine run for 2-3 minutes to become warm
before operation.

To stop the product : EBZ8550RH

CAUTION: Do not stop the product at full
speed.
1. Push the throttle lever to the stop position.
962 - 003 - 01.02.2019